Network Security

I have two concerns regarding Cisco NAC.Will it work for Cisco customers running something else than Microsoft on their clients?Why does Cisco not develop NAC towards LDAP instead of AD?As far as I see it this whole NAC thing is just a big Microsoft-...

This Sunday morning I'm upgrading our PIX to version 7.0. Any problems I should look for before, during or after the upgrade.

Is there any way to set JUST the signatures to default in 5.x? I tried doing a select all->default from the GUI but it eventually just times out with some rdep error. I also just tried doing it from the CLI using :(config)# default service signatur...

Started learning for the pix exams and wondering if there a simulator for pix 6.3 or 7.0 Or i need buy a real device to use for the learning?

I am trying to put the IDS-K9-patch-4.1-4g patch on a couple of 4215's and every time I run the upgrade command it times out and fails with a zero length file on teh IDS. I have also tried to manually (from service account) move the patch to the sens...

I've configured the management interface of a 5.x 4235 sensor to be 100Mbit/full. It is still HALF duplex according to dmesg output and I am still seeing collisions in proc/net/cisco/ge0_1.info. Does anybody know if setting this via the CLI actuall...

If I have an a Pix that support vlan can working fine this configuration with two subnet that have surf on internet with PAT ?thanksLorenzointerface ethernet0 autointerface ethernet1 100fullinterface ethernet1 vlan2 physicalinterface ethernet1 vlan3 ...

Is SMS2003 supported as a method of rolling out CSA Agents?I have an unusual situation where the CSA agent kit is not being successfully rolled out by SMS2003, when retrying the process, I receive a warning that the agent is already installed, even t...

I recently added a 4215 to VMS for management. The 4215 has s172 on it - which I have been trying to upgrade with no success. I am trying to push out s188 to it before I upgrade it to the newest service pack, etc. The problem that I am having is that...

Let’s be real -- the IDS documentation is miserable. It goes on endlessly without stated objectives and many of the screenshots are messed up. Ideally there should be a bunch of field notices that explain specific tasks. For instance, how to connect ...

We have a VPN 3K Concentrator. The users would like to access Microsoft Outlook client instead of webmail through VPN. Do you have any suggestions on where I would start?Thanks.

Hello, I'm a newbie with the asa 5510 and I try to setup dhcp relay on this firewall.I have the following configuration:inside 10.0.0.1/255.0.0.0 security 100outside xxx.yyy.zzz.uuu security 0dmz 192.168.0.1/255.255.255.0 security 50I have a DHCP Ser...

Hello Everyone,We have two PIX 515 in a failover configuration at a data center and everything works great! I would like to purchase an additional PIX 515 UR for Our office LAN. But before I do I need to know if it is possible to configure the PIX t...

Hi guys:Have a question for anyone who can help me sort this thing out. We have an SBS 2000, 34 users, with a single network card, attached to a Cisco 506e firewall, connected to a Netopia Cayman Router (DSL). We tried to upgrade our DSL conection as...