Network Security

Version 4.1(5). Is there a global way to tune by IP(s) such that the IP(s) continue to show up, but never alert? Example, for IP 10.0.0.1 I want no alerts for any signature, but want to see the events.

After upgrading to VMS MC to 2.2, we need to add new sensor to MC, but it does not seem to work. It actually went through the "Add Sensor Summary" screen. Click Finish. No new sensor added to the Management Centre of IDS Sensors. No error message wha...

Hi, a couple of questions here, firstly I understand the uauth settings on the pix are as follows:timeout uauth - 5 mins - Sets the duration before the authentication and authorization cache times out and the user has to re-authenticate the next conn...

Hi, I have lead an error " Analysis Engine is currently busy apply update later" while upgarding 4.1(5)sensor with signature 4.1(5)S195. please let me know how to get resolve this issue.ThanksMasood

I am running 4255 platform with version 4.1.5. This has proven to be a real nightmare to update signatures. Before we do any updates we have to be careful and remove the previous updates so that it does not fill up the slice and dies. Even by doing t...

Hello all, I have an IP Phone on Inside, the IP Call Manager is located on the dmz, all the the ports are open between this two devices (permit IP), moreover, I can ping one device to another. But the Ip phone is unable to make a call, no dial tone. ...

Folks, I am looking at the log files in my VMS server and they are much bigger in size than the recommended values, am i use to manual clean them up or can i automate the process.Thanks

HiI just upgraded from a PIX515 to an ASA5520, every thing works fine except that behind the ASA are HTTP servers and users need to upload and dowload JPG´s that is done through HTTP, when the files are large it just stops half way through the downlo...

When trying to upgrade PIX 525 from ver. 6.3(4) to pix702.bin via the "copy tftp flash" command I'm getting "tftp: Timed out during transfer". Tried differnet servers, differnet TFTP clients & even tried differnet images (pix702.bin, pix702-5.bin)red...

my server(host) connect to pix inside port directly,it can't ping pix success.there is no host firewall on server.when i in pix monitor mode .from pix can ping server successful.how can i resolve this problem?

Have a pix with Internet connections on 2 different interfaces in two different subnets.Would like to have a default route with metric 1 pointing to Internet router on one interface, and another default route with metric 2 pointing to Internet router...

have tried just about everything to get my inside users to get traffic back through this pix, but no go...we have no need for nat, so we did the whole nat (inside) 0 0 0 thing, so traffic gets out. then to get responses back in, applied an access-lis...