Network Security

I currently have a 3005 ver 4.7 using SDI 5.0 for Authentication. The only options for authentication are 5.0 and pre 5.0. We are looking to upgrade to RSA Authentication Manager 6.0 - I cannot find any documentation that says this is supported. Can ...

Hello to all,I had a customer question me re a recent installation of a pix 506E ver 6.3.4) that they are having trouble sending and recieving email attachments. I wanted to make sure that the pix doesn't have the ability to strip attachments? They a...

When we do a show run on the pix the config continually scrolls all the way thru the config. it no longer pauses and waits for us to hit the space bar to continue. How can we get it to quit scrooling all the way to the end of the config?

Folks, I have a Sup 720 running in Hybrid Mode. My question is that can i use IOS IPS on it and monitor multiple Vlan in it. Means that the IPS interface command would be under multiple Vlan interfaces? is it possible?Thanks,

Upgraded 6.3 to 7.0 on 515E, purchased FO license for another PIX 515E. For some reason the Primary PIX wants active/active failover. I have not configured any contexts in the config, i assume it is on by default? This wont work with FO license, from...

I want to implement a vpn concentrator on our network instead of having the pix as the end point for remote access. Is there an advantage or disadvanage of this solution???? Any advice would be greatly appreciated.

Folks, I do not see any option of setting clock in the new IPS CLI. I used the setup command and adjusted the time zone to EST and 5 hours offset, now it is showing in incorrect time??Thanks

When I go to apply the update, I get the following error:Broadcast message from root (Mon Sep 5 02:27:23 2005):Applying update IDS-K9-sp-4.1-5-S189. Shutting down all CIDS processes. All connections will be terminated. The system will be rebooted upo...

Hi People,I am installing my first IDS/IPS vers 5.0 next week and I have everything pretty much in check with regard to config.However there is one aspect that I am not clear on and can find no information on, that is how to you physically cable the ...

I have a PIX 515E in failover with another 515E. Everything has worked fine since over a year. Yesterday I was asked to reboot the primary PIX, so I did that via a remote SSH session from the outside and I used the "reload" command in privileged mode...

I have a Cisco Concentrator VPN setup which hands out addresses from a specific subnet via Easy VPN. Now I need to establish an IPSec tunnel with a non-Cisco device. I can establish a LAN-to-LAN tunnel via IPSec, but how do I replicate the Easy VPN s...

I'm tring to establish a VPDN over an MPLS network. On the PE where the VPDN is terminated I get this message:Aug 31 11:15:34: uid:35 Tnl/Sn 46930/36 L2TP: Cannot find dialer interface for callbackDoes anybody have experience for this kind of solutio...

Hy,asa 5510 with 7.0.2 version and icmp echo traffic from dmz host to an outside host and echo-reply from the outside host to dmz host.If I remove the specific ace of the icmp, the traffic still goes-on even if it remains only the ace "deny ip any an...

Router A (Serial Port) in location A is connected to Router B (Serial Port) in location B through an IP VPN connection. How will I be able to determine the actual bandwidth utilization of the link between Router A and Router B? Thanks