Network Security

I´ve created a new vpngroup and assing it a range of ippool similar to the first one. My clients can login using the new vpngroup but they can´t see my LAN and I can't see themI don't know what's wrong????For every new vpngroup, should I have to crea...

I have a 1760 at a remote location and a concentrator 3000 at my main office. Is there a easy way to setup a vpn between these two devices?Thanks

When trying to retrieve IPLog traces or the trigger packets from the Security Monitor, I get the following error message:Packet Viewer - ERRORjava/awt/Component: method getHeight()| not foundUnable to initialize Packet Viewer.Of course, the trace doe...

I have searched EVERYWHERE for an answer on this but I can't find a thing. Our IDS worked fine for a few months but now all the alerts just say ALARM FEED INACTIVE (Cannot connect). I have rebooted both the sensor and the agent various times, checked...

Just a short question: does anybody know how long will there be development of signatures for 4.x sensors ? Will they be for free or is there also subscription on the way ?THX

So, I'm looking at the NAT-control command in PIX 7 and thought of a hypothetical situation:1) Let's say I disable NAT control with the 'no nat-control' command. I have public IPs in my DMZ, so I don't want to have to mess with a static statement to ...

Hi All,The command 'copy flash: tftp' is not seen in ver 6.3(3) but is available in 7.0(1)Version 6.3(3)PIX# copy ?Usage: copy capture:<capture-name> tftp://<location>/<pathname> [pcap] copy http[s]://[<user>:<password>@]<location>[:<port>]/<pathname...

HiI am using exchange 2003 server in my network and it is connected to inside interface of the pixfirewall which goes to leased line. In the firewall I have given a static nat for the exchange server also I have 16 global IPs nat to internal network....

Hi ,Who can tell me how to config ipsec over GRE tunnel when remote side useing dynamic ip !Thanks!

how do you enable a permission for a passive mode FTP connection, is it just by using the fixup protocol ftp 21 or is there other commands that need to be implemented also?Your response would be much appreciatedThank you

None of my static nat work on the new version. I keep receiving deny src outside (address) to local address by access-group outside_access_in

I had to recover a sensor to s47. Before it went down the sensor was at s159 in the VMS MC. How can I get the sensor back up to s159 without losing all of my settings/filter/custom strings, etc?????????

The release notes for PIX OS 7.0.1 state:"PIX Version 7.0 runs on PIX 515/515E, PIX 525, and PIX 535, but is not supported on the PIX 501 or PIX 506/506E platforms at this time."Does this mean it can be installed but is not supported by Cisco or it j...

Hi,are there any detailed information about BUG CSCeh32156. Our customer updated to SP2 and the release-notes containes small information about this issue.With SP1 the BBSM 5.3 had the problem: reboot to irregulary moments. May be also caused by too ...

Hi,Can someone help with what the correct steps are for replacing a primary PIX firewall unit. Here are the steps I followed, but it did not quite go to plan:Replacement of PIX Primary Unit:1. I forced the standby to become active by issuing the "fai...