Network Security

I have a PIX 515 and VPN client 4.01. When I use a dial up connection the tunnel works fine and I can see the internal network, but when trying to connect from another network (I suppose they have some firewall) or from my GSM phone (GPRS) the tunnel...

Is there any way to limit the bandwidth in Cisco PIX 515E?Regards

Hi,I'm using the Cisco VPN client 4.0.2 on windows XP and 2000 computers. I want to set the MTU to 1400. For that, i've used the "set mtu" cisco software. After my computer reboot, the mtu size is still 1300 bytes and my traffic is fragmented.Does an...

Is it possible?I have Ospf configurated with a router internet and I have second router that it isn´t running ospf on that.I have a static default route configured on second router with metric 120(upper than OSPF)The router configured with ospf is se...

Hi I am setting up a PIX515e firewall and cannot get it to work properly. We just want to start with a basic setup. The IP internal network is 172.18.1.xxx and the internet connection it though Verizon DSL and a small Netgear router. The router IP is...

Can you have two default routes with PIX 515? My goal is to be able to hook two interfaces to different routers. Each of the routers will be using BGP and they will serve as a redundant internet connection. This would require two pix interfaces an...

Has anyone got any news regarding the OS release 7 of PIX firewall? Any information as to what new features will support, what is the minimum requirements and when it would be available?

Hi... hopefully someone will be able to help a PIX newbie like me... here's the problem. I am moving from an ISA 2000 firewall server to a PIX 515E. Our network is on a 10.0.0.1 - 10.0.5.254 "network." I have two lines to the internet, however, which...

I have an issue with devices running Windows CE. Specifically HP IPAQ h4355 pocket pcs running Pocket PC 2003. If the device is configured for DHCP an IP address will never be assigned to he hand held when in the same segment as the PIC running DHCP ...

"305006:portmap translation creation failed for udp src inside:192.168.1.xxx/port_number dst outside:199.xxx.xxx.xxx/port_number"I get this after creating a rule to allow access to a terminal server on our internal network. I can access the server f...

I am running PIX 525 6.3(3)4 interfaces 2 FE, 2 GE1 FE used for stateful failover1 FE will be used for DMZ1 GE inside1 GE outsideAttached to 6509I set GE-outside to VLAN 201 on the 6509 the fiber port it is plugged into is VLAN 201I set GE-inside to ...

Could some one please direct me on where to find literature on CISCO IPSec shared keys verses IPSec Internally generated Certificate based. If there isn’t any literature on the comparison of these two than the pros and cons of each would be good enou...

Could anyone assist this issue ?Whenever I tried to upload the file in Common Services License Option then it shows License file may have been corrupted.

I'm trying to configure Policy NAT on my PIX 515. According to Cisco docs, Policy NAT is supported on PIX v6.2 and higher. My PIX is v6.3(1). So I assume it supports Policy NAT. However, when I type in the command "nat (inside) 3 access-list acl-...