Hi everyone. After upgrade cisco ASA version and ASDM version too, our login via LDAP does not working. Through local logins it is possible. We have got 2 Cisco ASA's in failover state. I reloaded both ASA's, restore old config, check configuration o...
Hi We have wlc. and got the below vulnerability message from tenable. Now I have two questions:1, in addition to upgrading ios, there is other way to resolve it?2. We scan all devices all the time, and we did not get the below warning message before,...
Hi, I have upgraded my ASA 5508-X with version asa9-12-4-39-smp-k8.bin ASDM stoped working please suggest.
Hello all! I have a couple of ISA3k devices, which have lost FMC connection after losing power. More than that, they show no FMC configured at all: > show managersNo managers configured. But if I try to add one it reports DB loss: > configure manag...
Hi! I'm planning a firepower upgrade from 6.4 to 6.6 and need to add a rollback procedure, and was wondering if I needed to re-image the device or there is something easier like uninstalling a patch?
Hello, I have customer that was planning on installing two 2130 and two 2140 FTD appliances, but due to production and delivery issues, we were forced to install a couple of temporary FTDv. The hardware appliances have now arrived and I'm looking fo...
Dear AllI am working with firepower management center 1000as you show in the picture i have deployment task from old time 8804 hours , and Knowing that there is every devices is up to date Does anyone have a solution here? Regards
Hi All, I have updated firmware for ASA 5510 after upgrading my most of the IPsec tunnel down anyone have any idea what is the issue with that. Anyone faced this issue??
Hi All, We have a Cisco ASA that is connected to the network using a singe port-channel interface. We then use sub-interfaces for each ASA logical interface such as inside, outside and DMZ. When it comes to monitoring the logical interfaces for failo...
Does a specific rule need to be created on the ASA to block IPv6 traffic, or will the default block deny the traffic if no specific rule is in place?TIA
Does FTD support SSL VPN (clientless and anyconnect) in multi-instance
Dear Patrons! We have installed ASA version 9.13.1(10) on Firepower 1140 but during initial configuration on the FX-OS getting the below error, Firepower-1140# scope fabric-interconnect a Firepower-1140 /fabric-interconnect # set out-of-band ip x.x.x...
After several policy imports from ASDM to FMC I am going to migrate some policies created through CSM. The tool is still the same (Firewall Migration Tool 2.5.3) and the firewall model is the same as the previous ones (ASA 5585) but after the migrati...
Hello Experts, @Marvin Rhoads @balaji.bandi @Rob Ingram I have an IPSec tunnel setup with Cisco ASA and Sonicwall NSA. The tunnel works fine with some packet drops and it happens on Sonicwall. I worked with SonicWALL Support and found that ASA sen...
Why is my HTTP Response for blocking a certain site using access control policy, i am using FTD 7.0.1.1 and FMC 7.0.1.1. i always get this response below:
