Network Security

Hello,Could anyone recommend software tools for VPN benchmark testing? I would like to compile network statistics for a site-to-site vpn over a period of several days. During that time I would generate various network loads and failover scenerios. Th...

Hello,Need someone to review the changes being made:Need to block gotomypc.com on a PIX 515. Based on my research a host called poll.gotomypc.com (66.151.158.177) needs to blocked to prevent users.Here is what I am planning to add to the config:acces...

HeyI have a PIX 501 and i want to be abel to acces my webserver(172.16.17.4) from outside on port 80. How do i do that??My config looks like this now. No matter what i try it doesn't work. I have 1 public IP-Address.Building configuration...: Saved:P...

Need opinions on the best platform and hookup for PIX running in failover mode. We currently have two PIX515 in FO mode (using cable and Ethernet for the state). We have frequent lost of communications on the inside and outside I/F. So the boxes keep...

What is the command to clear the counters on PIX interfaces. Can't find it any where, and "clear interface counters" does not work. Running version 6.3(3). Thanks!

I am trying to configure pix 515e. I have inside address 192.168.1.1 and outside address 63.67.x.x ip address inside 192.168.1.1 255.255.255.0 ip address outside 63.66.x.x 255.255.255.0nat (inside) 1 0 0 global (outside) 1 interface My router address...

Can anyone refer me to documentation on the Cisco site that talks about high-availability options and configuration examples for Cisco IDS/IPS 42xx appliances? Thank you in advance.

We are running VMS 2.3 and are trying to install the Cisco Security Agent 4.03. We keep getting the error "Unable to assign SA password". We uninstalled 2.3 and MSDE, shut down all resident programs (AV, etc.). Then follwoing the CISCO MSDE instructi...

No matter what I try I cannot get the IDS to fire an alarm on a custom service.http signature I'm trying to write. All I want is an alarm to fire when an internet user tries to issue an http request: PUT /index.htmNo matter where I add the RegEx or w...

I am setting up a vlan on a layer 3 cat switch behind our pix. I have routing setup correctly on the switch and I have a route inside statement setup on the pix. the hosts on the new vlan subnet can access the internet through our subnet but cannot a...

I would like to know if it is possible to install Cisco Security Agent on my CallManager without haveing a Managenent Center.If yes, what are the principal differencies with the utilisation of a Management Center ?Thank you for your help.

Is it possible to use a TACACS server(ACS 3.3 in our case) to authenticate IDS admin users? I can't seem to find this anywhere in the documentation. Thanks.

Hi,In order to allow Users to save their VPN-Password in the Connection profile of VPN Client, an Attribute called "SaveUserPassword" must be set to "1".But this setting is reset every time i connect to our central PIX 515. How can I tell the PIX to ...

Our existing restricted license PIX devices do not seem to be utilizing the VAC+ cards that we recently installed in 3 PIX 515s. From what I've read, it should just work. Here is output from two of the devices:Cisco PIX Firewall Version 6.3(3)Cisco P...

Hi, I have just acquired a Pix 501 with 10 user licences and i do not have any knowledge in configuration of firewall. My existing network consists of a Aztech Router cum ADSL modem and a Cisco 2900 switch. I am using dynamic IP address form my ISP f...