Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
I have a PIX 520 running on 5.3.3. I want to monitor CPU utlization. I tried this OID:1.3.6.1.4.1.9.9.109.1.1.1.1.4.1and it did not work. If anyone can give me any tip on how to monitor cpu utlization?
Hi All,I am having an issue with Pix 506E.The pix is running fine, but the owner wants Exchange2000 Outlook Web Access configure. So He can receivee-mails from anywhere.Anyways, I got it working and it runs good.But then no one can access internet an...
Has anyone seen a situation where a PIX 515 primary locks up with the above error code and doesnt switch to secondary. what is the cause of this error code.Many thanksIan
Ok, so the alias command was working for about 40 minutes, now it doesn't work anymore. I haven't made any changes. Now when I ping the FQDN, it times out, and when I try to access the site via browser using FQDN, I get a DNS error. Rebooting the PC ...
Hi,I have one question regarding lan based failover connected pix-es (one pix with UR + second pix with FO license).If primary unit (UR license) failed, secondary unit (FO license) will be active unit. Theoretically, I won't be able to change/repaire...
Can I configure IDS on the PIX. I have looked through the documentation on the Cisco web site but could not find anything except how to configure shunning on a PIX using Cisco IDS UNIX Director. I don't want to use any external device and would like ...
I have a webserver setup behind my PIX firewall. It is also a mail server as well. My problem is that when I try to browse to a website I only get the first page and every subsequent page times out. I also can not receive mail. Below is my config. Ca...
Hello:I have a problem with nat (xlate) in my firewall pix 525 with 6.2.1 , I have 6 global group for nat my inside address to access internet (1517 with global + 166 in static = 1683 total ). In sometimes my users aren´t able to access internet and ...
Hi All,I am just starting to play with a PIX and I am wondering if it is possible to configure Etherchannel on it. Can I have also a link to the appropriate Web page?Thanks
The firewalls ended up being primary with the same address and MAC. I later notice looking at the logs that both were going back an forth from primary to secondary 3 to 4 times a day since the upgrade. After it did that twice during the same weekend ...
From what I've read about these two commands I can't see any difference (in a L2TP environment anyway). Both will copy the PPP payload ToS byte to the L2TP header ToS byte where it can be used by outbound service policies. Is there any fundamental d...
I'm sure this must have been asked before but... Given service policies with CBWFQ and LLQ aren't allowed on virtual-access interfaces how can a service provider guarantee bandwidth and latency to VoIP or other priority traffic over a single PPP sess...
Hello,On a PIX501(6.2) with VPN Client (4.0.2), the Vpn connection is ok, but I encounter this problem :- ping from client (192.168.229.1) to lan (192.168.42.x) fails.BUT :if I ping first from Lan (192.168.42.x) to client (192.168.229.1), then a ping...
