Network Security

Trying to install a 501 on a small business network that is hosted by another company. They currently have it set up with 172.17.xxx.xxx for their internal LAN and have it routed(?) to be 216.201.xxx.xxx on the outside.I set the inside address to the...

Hi,I am having problems with configuration of a Pix 501. This is the first time that I have set up one, and I can't get inward NAT to work. Here is a copy of my configuration : The problem is, is that if I try to open a http session to 193.x.x.67 fro...

Hi everyone,I would like to know, if anybody has a Cisco URL, for how configure a Pix Firewall with 6 interfaces (inside, outside,dmz1, dmz2, dmz3, dmz4) without nat.Thanks in advance.

I want to use cbQosPoliceConformedBitRate to graph bandwidth for QOS policy. I am not able to figure out what policy goes with each entry. When I do a SNMP walk I get cbQosPoliceConformedBitRate 1915.1923. cbQosConfigIndex 1915.1923 = 1819, but cbQos...

How do you block a host, say host.where.com at the firewall level. I'm using the PDM.

As mentionned in the PIX 6.3 specifications, we are able to nat outer address on less secure interface on the PIX (6.3).In my case, I have a connection to open from a host A (192.168.40.40) on the inside interface to a host B (10.125.125.125) on the ...

Hi,Does anyone know what the syslog message code is when the secondary pix becomes active? I have it set to information and I cannot find the line. Do I need to set syslog to debug to see these messages?Thanks in advance.-J

Please let me know whether we can do etherchanneling in PIX firewall.

HelloUnfortunetly I canot paste a diagram to make my self clear but I will try to get my questions across.I have always seen PIX as a device that seperates the network in to sections ( eg. DMZ, Internal..). You could use failover to recover from a fa...

Hello,I've got a problem: the large part of PIX syslog messages can't be send to my syslog server. I execute 'show logging queue' command and have the following output:Logging Queue length limit : 512 msg(s), 48204719 msg(s) discarded.Current 513 msg...

I Purchased and installed new PIX 501 about two weeks ago. Along with some excellent board help, It is working great. I see on this board that there are referneces to PDM v 6.(3).3. I have v 6.(3).1. If I should upgrade, please tell me where to get t...

newbie here,how to reset firewall to original config? or see original PIX 501 6.3 (3) configs?Any help is appreciated

If I preload a new OS on a PIX, with intentions on booting it at a later time, does the new OS I copy onto it disturb the functionality of the PIX before its rebooted? In other words, will the PIX know it has the new version on it until it is reloade...

I posted a message on the Ask The Experts - PIX Firewall topic asking if it was possible to do active/active failover with two PIXen and also have loadbalancing, without having to use a content service switch. The reply back was "yes" but did not ela...