Network Security

In Topology manager device type column instead of seeing "C2950G" description i am receiving "Ciscoproducts.429 description" . When i look at the view, all 4 of the C2950's have question marks on them. Why is this?Thanks.

I have 2 PIX 525 unrestricted bundle. Everytime I type wr mem in the pix it slows down tremendously. I have a continuous ping going from a device on the directly connected internal network. As soon as I do wr mem the ping round trip goes from under 1...

I want to integrate a virus scanner m/c for http taffic and mail traffic with PIX. The virus scanner m/c is required to be put at DMZ. How can I do this and how shall I write "ip route ......." command for this purpose.--ejaj

hi all just got a pix 506 with ios 5.2.xx want to reset it tofactory defaultthere's a password how do I set it up to factory default?or change the password ? how do i run pix device manager for gui configuration

Hello,I was wonderning what would be the best practice for making visible a particular internal IP address on the DMZ segment?I have tried both ways, using nat 0 for that particular IP address and using static nat, both ways are working fine. But whi...

Hello,i´ve installed PIX Version 6.3 for HTTPS Authentication. But there is no HTTPS Virtual Server so i have to connect a HTTPS/HTTP Server behind the Firewall to authenticate. The Authentication Site on the PIX looks very unprofessional. Now my que...

I have routing problem on internal interface with pix firewall (O.S.version 6.1.4).

I wish to upgrade a PIX501 from 6.2 to 6.3 to enable remote management (SSH etc) via IPSEC VPN.The problem I've encountered is that the PIX 501 won't seem to communicate to/from a TFTP server on the inside network.I've tried:wr netcopy tftp flashtftp...

We recently changed ISP and as a result had to change our IP addresses.I made a note of the old addresses on the config and changed them to the new addresses this evening.We can connect to the Internet, and the VPN clients connect to the PIX, but we ...

I have a quick question, i have a LAN to LAN tunnel setup between two PIXs, if i setup telnet for the other side of the network, can i telnet to the internal interface of the other side of the PIXnetwork A-----PIX A--------VPN Tunnel--------PIX B----...

Scenario:To pix firewall's DMZ interface is a 3600 series router connected and to outside interface is one more router(3com or cisco) connecting to the internet . Solutions required :Currently i am accessing internet through outside router . Now i wa...

New in version 6.3 is the route-map command for use with OSPF. Does anyone know if it can be used to policy route based on static routes.Here is what I want to do.Outside ISP 1 ------- PIX Outside InterfaceOutside ISP 2 ------- PIX DMZ InterfaceInsid...

Hello, I want to confirm that it is not possible (with the default config) to get inside clients (static and natted) to make a PPTP connection through the PIX? Is this correct? I know that 6.3.1 supports the pptp fixup prot, but I am very hesitant on...