Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
May anyone tell me how to know if my PIX 515E is Restricted or Unrestricted? The software version is 6.1(4), max interfaces is 6 and failover is enabled (info got from "sh version command" )Thx and best regards,Rafa.
We have a location that has a new Internet Circuit installed and a new PIX 515E. The site had pre-existing HP PRocurve 8000M switches installed without VLAN setup, Spanning Tree was setup. The PIX firewall is utilizing 3 ethernet ports (Inside, Outsi...
Is it possible to terminate a PPTP on a PIX and then assigned an IP from a pool configured on the PIX then be able to access the outside again through this IP, how can the routing of this scenario be configured on the PIX??? I know i am asking for so...
Can we give the IP address on outside and dmz interface like 10.10.1.2 and 10.10.1.3 respectively.Can we have the same subnet for the two interfaces.Any help would be appreciated.
By default pix allos unresticted outbound access unlesss something is explicitly denied. 1.Then is it true that: any permit statement applied to traffic coming into the inside interface is redundant, for egaccess-list acl_in permit tcp any anyaccess-...
Is there a sample of a configuration for allowing a pc behind the PIX to browse the Internet??? I have tried Static, NAT and PAT and still cannot browse the Internet. With a static command I can access my remote PIX's with SSHand I have no problem im...
I am trying to configure a PIX 515e to allow a "stub" network to access the Internet via the PIX. The "stub" network is across a WAN connection using a private IP. I can ping the firewall inside address from a host on the stub network, but can't ge...
The following message appeared in my PIX firewall log:500004: Invalid transport field for protocol=17I know protocol 17 is UDP but I don't understand the rest of the message.Can anyone help?
Hi there We are experiencing problems connecting to Sun Solaris machines through a Cisco PIX 525 firewall(IOS 6.2). In our initial testing, our firewall administrator opened all ports(TCP, UDP, XDMCP) and allowed all traffic from any IP address. How...
I need to setup a mulitcast server on my DMZ, which the internal users will use. As far as I know you can't send multicast through pix. Does anyone know I can I do this without having to buy any additional hardware. Any help would go a long way.Th...
I have loaded the VPN Client 3.5.1C on a Windows 98 and also Windows 2000 client. On both systems, when I start the VPN Client, the following message is displayed:"The necessary VPN sub-system is not available. You will not be able to make a connec...
Does anyone have the problem of Ciscoworks being dog slow on W2k?Is there any cure, I have 1gig of ram and it's on it's own server, do you just have to live with it?Bill
