Network Security

Hi, i understand the purpose of the "inside", "outside" and "ip address failover", however what does the "unused" interface accomplish?Thanks

I have a Pix 501 connected to a DSL Modem using pppoe. The PDM is 6.2(1). In this case i have just one Public ip address.Can someone tell me how to host an Microsoft exchange server behind teh pix, and make the smtp relay service work correctlyThanks...

Hi, i have two Pix's, one Active the other failover - pointing to two routers (each connected to a different ISP configured with HSRP. My question is, obviously the PIX cannot run any dynamic protocols except RIP (which is not an option). i have a s...

I'm trying to setup L2TP/IPSec to PIX connection, the example suggest to use CA for client authentication. 1) is it necassary to use CA for L2TP/IPSec connection?2) if so, i have already setup a CA server, what is the CA script location which i could...

We have had PPTP working for several months on a PIX 515 pair up until last Wednesday. Since that time no one has been able to connect via PPTP. Cisco VPN 3.x clients are working OK. As far as I can see, no changes have been made to the PIX config in...

Hi,is it possible to use connect via a checkpoint secure remote client to a cisco pix?Any help is much appreciated.Alex

Was wondering if any of you have seen a problem similar to this one. Not sure how long it's been going on. We found it while logging some email traffic, and noticed that a great deal of traffic is from the second and third servers listed in the MX re...

I've been doing some config changes and wanted to go back to the default config and used the command 'clear config all' and I cannot now return to the PDM or use telnet. What can I do to get back to the Pix PDM or CLI??? Thnks.Barry

Hi,I have recently had a PIX stop forwarding traffic because of the 'reliable TCP syslog' feature, the syslog server had gone down.To stop it happening again I changed the PIX to use logging via UDP instead, however the same thing happened again a co...

I have create PPTP connection between client and PIX, but i just wondering, are there anyway i can apply ACL to this connection. Look forward for any suggestion, thank you

One of our vendors is attempting to send print jobs through the PIX to one of our HP4000 printers (which is using a JetDirect card - IP only protocol used). The first series of reports prints fine, but when the computer on the other end sends the se...

I have and old PIX and I am tring to find out what the model is. This box has a floppy drive in the front and 6 slots in the back . the power switch ,console failover,and power supply are in the back also.all that I can find to identify what it is is...

I tried to copy config of PIX 520 to tftp but got got failed message wilth unknown reason... wr net tftp:filename Regards Raza bhutta

Is there away to block streaming audio/video using a pix 525? Or can you limit the amount of bandwidth that they can use from the T1 so that not all the bandwidth is used?

Can anyone tell me what would cause this message to display when we reboot our PIX 515.WARNING: access-list protocol or port will not be usedThis is warning is displayed in the last line of the start up routine.Could a setting in the configuration be...