Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi Cisco Community,This is my first post and I'm an accidental ASA 'administrator' so please be 'gentle' :).I just started configuring a brand new ASA 5516-X which is to replace a very old 5510 (ASA 8.2(2), ASDM 6.2.(5)So far, I've setup the outside ...

BoSa by Visitor
  • 1541 Views
  • 1 replies
  • 0 Helpful votes

Hi All,We have just purchased a newly Cisco 5516X and it is in FTD mode, this has not yet registered to smart software licensing server. We would prefer it on ASA mode so it can be easily managed through asdm.   Can I just do the instructions from ci...

Hello guys, I'd like to replace the ASA 5545X (with Firepower services) by Firepower appliance.Which is the similar model in terms of performance? Seems that OS is different, can I keep the old ASA CLI configuration and migrate to FPR ? Thank you ver...

h.dam by Level 5
  • 1721 Views
  • 2 replies
  • 0 Helpful votes

According to the Cisco Cyber Vision datasheet only the Cisco IC3000 industrial compute switch that is cyber vision compatible.....However that switch only has 4 ports so you would need to purchase quite a few to plug in all the end devices. In compar...

UT_games by Frequent Visitor
  • 7663 Views
  • 3 replies
  • 0 Helpful votes

Hello   I would like to upgrade the code on an ASA 5506-X with FirePOWER services and it's currently running 9.9(2)32 Cisco Adaptive Security Appliance Software Version 9.9(2)32 Firepower Extensible Operating System Version 2.3(1.121) Device Manager ...

Hi everyone,I am aware that the Cisco 827 is no longer supported but I am trying to figure out whether it is recommended or required to deploy a dedicated ASA Firewall for the sake of security and protection purposes of SOHO end devices behind the ro...

Rolitto by Level 2
  • 1833 Views
  • 3 replies
  • 5 Helpful votes

I currently have a FTDv managed by FMC (v6.4). I have configured an inside interface through the FMC that is connecting to an access switch with an IP address but did not add a security zone. Problem is I cannot ping that interface from the switch or...

Top Solution Authors
Review Cisco Networking for a $25 gift card