Has anyone implemented successfully or unsuccessfully the custom feed feature in FMC 6.1.0 (or later)? The feed list creation is in Object Management, URL Lists and Feeds. Our security group is constantly coming up with domain names to be blocked ...
Forum Posts
SCP to my firewalls in Japan and USA from the UK is painfully slow. I suspect this is because the firewall does not do any window scaling. If I copy from a local machine, I get a transfer time of about 1m30s for a firmware image. Transcontinental i...
need to limit bandwidth using ASA version 9.1 can i do it through it as to limit bandwidth for some devices and not exceed the limit
Hi, friends, I am using ASA5525, version 9.8(1) to work with Hirschman switch. The Hirschman switch has been enabled PRP (parallel redundancy protocol) . The ASA was placed in the middle to control one link.I have two link, one FO, one lan cable...
I've noticed that the latest suggested release of Firepower services (6.4.0.4) is only compatible with the larger 5508 and 5516-x firewalls. I have an environment with 2 5516-x, 2 5508-x and about 15 5506-x firewalls.I can't find a recommended "road...
Hello, I purchased a Cisco 2130 series firewall past 6.2.3 to at least 6.3 or 6.5. However, I am unable to find any documentation on upgrading the 2100 series firewalls without using FMC. I will only be managing it with the FDM. Is it possible to upg...
I have an ASA 5515X with two Providers and would like to be fault tolerant and pseudo load balance. I have bound my crypto maps to both outside interfaces and my remote sites (35) have both ISP's ip's of the ASA and can connect to either.... but not ...
Resolved! Bootvar and boot command
Hi all, I have recently upgrade our Failover Active/Standby ASA software. Everything works flawlessly. Except I have the following question regarding the boot and bootvar command. After the upgrade, both devices come with the new IOS image. However...
Hey All,I'm running an ASA 5550 out of my home network and, overall, things are pretty good. It acts as my gateway (ISP Gateway is in full passthrough mode, all frames get sent to the ASA), and does it's job well.I recently installed a 5508 WLC with ...
How we can verify that logging is enabled on respective rules through CLI in Cisco ASA 5585 Firewall?
I think NAT is REJECT on the ASA.Can anyone tell me why?I'm attaching Running-Config and LOG and a larger image below.
Is there any way to create alert when ASA firewall DHCP scope is reached at 80%? Does ASA create any log on DHCP usage?
Hi Community team, I need your help with the next case, maybe someone had the same issue I have a ASA5550 with 3 interface:- DMZ, INSIDE, OUTSIDE We have UDP traffic syslog from some host in the INSIDE LAN to the one server in the DMZ LAN. * When the...
Hello All, Our organization is in the process of connecting to the Department of Homeland Security’s (DHS) Automated Indicator Sharing (AIS) feed. After an update a little while ago to the Firepower Management Center we where given the ability to ...
Hi, New REST API based pxGrid 2.0 is supported in ISE 2.4, and is backward compatible with clients that only support XMPP based pxGrid 1.0 according to this https://developer.cisco.com/docs/pxgrid/#!parity-chart-between-pgrid-1-0-and-pxgrid-2-0/supp...
