Network Security

Dears, good afternoon. I come throw this forum in order to ask for help with a problem. Here in my work I am replacing an ASA 5510 with an ASA 5525-x.ASA 5510, OS 8.0(4) and ASDM 6.1(3)ASA 5525-X, OS 9.4(4) and ASDM 7.2(1) I did all the necessery mig...

I'm setting up some 2110 devices using FMC for an organization that has a specific change control policy that I don't know how to address with FirePower. The policy is to set the initial configuration as a baseline, and periodically audit the active ...

Hello community I am trying to find some documentation about secure syslog. I have to send syslog messages to a server by using tcp encrypted traffic. I only could find some and very slim information about implementing on a cisco ASA, but it's really...

I am trying to get my ASA added to ISE as a network device, but having issues with the aaa-server config and output. Here is the config I have:aaa-server ISE protocol radiusauthorize-onlyinterim-accounting-updatemerge-dacl before-avpairdynamic-author...

The device is FTD mode, registered successfully to FMC, and sent the configuration correctly. After one day or so, the device automatically offline, synchronization button can not restore the online. Check the connectivity and port between FTD and FM...

Hi Peers I have a 2 Cisco ASA Firewalls, each in separate sites i.e. Site1 and Site2 that is running site-to-site vpn. This is working fine. Both the LANs are able to ping each other. Site1 LAN Network Address : 10.10.10.0/24 Site2 LAN Network Addre...

Can anyone explain why Phase 1 is bidirectional and Phase 2 is unidirectional in IPSEC VPN. I read in one book that Phase 1 uses shared symmetric key generated by DH and both peers uses same key hence it is bidirectional. so in phase 2, are we using ...

We have a customer moving to a new internet service.  The ISP will be managing the site-to-site vpn tunnels between the different locations.  At the main office, we are installing an ASA 5506-X to act as the gateway/router.  I have posted the configu...

So I am just testing connectivity via IPs and Ports that I know for sure are allowed out on a VPN that has a ACL. The VPN exits the Outside interface however I get reverse-path failed when choosing the Inside interface (where source address would be ...

Hi,we had an RMa for our ASA 5516-XAfter rinstalling configuration backup and reinserting SSD firepower module, we still not see any firepower menu on aour asdm. any help please to recover this function ? we are using Asdm 7.9.1 and ASA 9.6.4regards,

Hi There, I am having FTD 2100 appliance managed through FMC appliance and recently implemented, when i tried to created IPSEC tunnel to remote site, while deploying the policy, its creating error. as like below. inputs on this is highly appriciated....

What is this process and it seems like it does not stop at all, even after rebooting the FMC multiple times.