Hi, dear: I have met an issue when I enable ipv6 feature on ASA 5512. I created prefix 2001:100:101::/64 for interface gi0/0.169. caowen-asa5512(config)# show run int gi0/0.169 ! interface GigabitEthernet0/0.169 vlan 169 nameif inter_vlan169 ...
Forum Posts
I've just tried to run up an instance of FTDv in a lab environment for testing prior to using on a customer site, the setup script allows me to manually configure a management address as usual, but this doesn't seem to be being applied correctly. I...
Hi All, I am replacing the existing firewall with Firepower series FPR 4110 model. I am getting issue in making interface up, Also after going through the config guide i have below questions 1. Is all the features are license based, including maki...
I have an ASA5512(Cisco Adaptive Security Appliance Software Version 9.8(2) ). I have Anyconnect setup on it and have licenses for up to 250 users. When I monitor the connections I see that the users are connecting with an SSL-Tunnel but they are o...
how can i fix the error taxii-service received code unbale to run to taxi cisco site how can i find the error and fix it
Hello, I have a situation where I need to configure port forwarding for traffic originating from a specific IP address on the Internet and is then destined for a specific IP address located within our inside network (RFC 1918) on UDP4500. We only h...
Hi all, It is my first time here. So, if I am doing something wrong, please let me know. I am implementing a monitoring tool in a customer - called OPMANAGER.I already exported flow and syslog. But the most important thing to do is: Monitore all the ...
Hi guys , Im trying to configure a port channel beetween ASA (active/stanby) <--> SW 3850.ASA Config interface GigabitEthernet0/1channel-group 10 mode activeno nameifno security-levelno ip address!interface GigabitEthernet0/2channel-group 10 mode act...
Resolved! How to debug to SSH session on ASA
Since upgrading from Pix to ASA, I haven't had to try to debug anything. Today I needed to debug an issue with a LAN to LAN tunnel coming up. I issued the commands I am used to using and so much debug information, not pertaining to what I am wanting ...
We wish to clear configuration on the ASA without removing licences can this be achieved by using either of the following commands write erase or config factory-default command?
My question is related to the Firepower subscription. I am wanted to add this to my lab for testing. I am leaning more towards the 5506-X 1. When you have the FTD image do you get any trial base subscriptions? Maybe for 30 days?2. Is AVC the same thi...
Hi all We have got two ASA 5525-x with sfr modules. They lived a couple off years without functioning on version 5.4.0. Now for test whe want to upgrade them with new software. One was easy.. without any error. But the second (did exactly the same) g...
Resolved! Allowing External Traffic on Cisco ASA
Hi - I have a Cisco ASA and I'm really struggling with something very simple. I have an outside interface and I would like to allow traffic to hit the outside interface on TCP Port 81 and get NAT'd to a private IP on a webserver. I believe I have the...
Hi Everyone,I am working on new setup where switch is directly connected to ASA.ASA int config interface GigabitEthernet0/2no nameifno security-levelno ip address!interface GigabitEthernet0/2.1description Central_Visitorvlan 360nameif CentralVisitors...
Hi Team, Can we implement Firepower 2110 as single entity rather than module for ASA ? If it is does it support routing protocol like BGP, RIP and OSPF
