Can i integrate firepower with fortisandbox ? if it is capable thank you to mention the method.
Forum Posts
Firewall Management Center Version 7.6.5 (build 106) OS Cisco Firepower Extensible Operating System (FX-OS) 2.16.1 (build 147)I have noticed today very slow web interface ... Health Monitorgrapthics are cutted, or "no data available"Then i caught a ...
Dear Community,I read in a post online recently that in some instances pushing policy to your FTD's from the FMC may cause the Snort process to restart, potentially causing traffic disruption. I was wondering if the following actions may cause traffi...
I'm looking at connecting an ASA cluster to a CheckPoint firewall cluster and told it will work.I've configured one interface on the ASA (inside) and cabled it up to go direct to an interface on the CheckPoint firewall (both have an IP in the same su...
Hi All,I was planning update my cisco FTD IPS(snort 3 LSP ) signature to latest via FMCv. During the signature update process, is there any impact on the ongoing production traffic as well as the established site to site VPN tunnels. Looking forward ...
I am experiencing an issue with the software image on a Cisco Firepower 1010 device. After performing a factory reset, I accidentally erased disk0:, which resulted in the loss of the system image. As a result, the device can no longer boot and is cur...
Hi all,In FMC, both IPS and Security Intelligence (SI) can be deployed in a detection/monitor-only mode for tuning and false-positive validation before enabling blocking.In FDM, I can only find a Detection mode option for IPS. SI appears to be block-...
Hello Cisco Community, Is it possible to run SOAR from Qradar to block IP on FTD. Also is it possible to import the feed (List of IP that we wants to block) for IP blocking?So currently our FTD is Registered on FMC, and we made rules on Access Contro...
FP-4115 running FXOS 2.17.0.518 and vASA running 9.18.4.67. Target vASA version 9.18.4.135. Is this target version the latest one supported for First-Gen FP-4115 with FPR4K-SM-24S ?
Hello,I've two old ASA5505 that I believe are security plus licensed.But i've lost the power outage (that is special 48V) and can't start them anymore to enter a "show version" and verify it.Someone wants to buy them but would like to have a proof th...
Hello, I would like to understand what the difference is between the two types of backups offered in the FMC. For the FMC configuration backup, I understand. But what is the purpose of backing up the devices? Since the configuration is managed by the...
I’m currently running a Cisco ASA 5506 on version 9.8(2), but I’m unable to use the Policy-Based Routing (PBR) commands. I can see options like policy-list and policy-map, however the policy-route command is not available to apply on the interface.Co...
I inherited a Firepower FP4110 that is running the latest version of FTD 7.0.9.1.13 but the FX-OS is version 2.10.1.159 (released in May 2021). For compliance purposes, I have been told to upgrade the FX-OS to the latest version 2.10.1.383 (released...
Is this CSCvn31571 a bug or by design that I can't have duplicate VLAN-ID on 2 or more sub-interface?
Does anyone know if it's normal for the Cisco Talos Feed to have 0 objects in the BOGON list? I found when mousing over the "Bogon" in the block list it shows 0 objects. In FMC, this is under Access Policy > Security Intelligence > Block List.Secur...
