Cause i = 0x8081 - Unallocated/unassigned number

[marlon-chung]

Hello,

We are running CCM 4.2(1) and all outbound calls fail over PRI. We have a few DID's and incoming calls are successful. The gateway is a 2821 with MGCP. The Telco did put a analyzer on their switch and the returned messaged is indicating that the numbering plan is unknown.

The image on the 2821 is

c2800nm-advipservicesk9-mz.124-17.bin

The numbering plan used is CCM is NANP. I have attached debug messages for outbound calls and incoming calls as well as the running config.

Thanks, any info would be great.

Marlon

[marlon-chung]

All inbound and outbound calls are working perfectly as it turned out, it was a telco issue with translation on the telco DMS-100. So to sum this up, it was never a CCM or 2821 gateway issue.

Thanks for all that help and provided their advice.

Blue Skies Forever!!

Marlon

[allan.thomas]

Thanks for the update Marlon, although it was suspected it is always difficult to prove this to the Telco.

I take it that you were unable to test using H323 in the end.

Regards

Allan.

[marlon-chung]

Allan,

No, we didnt test H323. Thanks for your help

Marlon

[e.hawkins]

I had this problem and it turned out.  That I was stripping the 1 off long distance calls on my route patterns.  The telco was expect a 1.

Hope this helps someone.