Hi Rakesh,
Try this.
1) Using the CallManager Administrator interface, create a user for each Microsoft Outlook user who wishes to use the contacts. Make sure that in the global directory, the user has the Enable CTI Application Use checkbox checked, and that the IP Phone is associated with that user.
2) Download the Cisco Telephony Service Provider installer from the Cisco CallManager Install Plugins page to the PC on which Microsoft Outlook is installed.
3) Double-click the downloaded executable. The installer proceeds to install Cisco TSP. Click Next.
4) Choose the setup language
5) Click No when asked about multiple instances of Cisco TSP, unless you want to talk to multiple CallManager clusters.
6) Once the installation is finished, you need to configure Cisco TSP. To do so, go to Control Panel > Phone And Modem Options. When the Phone and Modem Options window opens, click the Advanced tab, then select CiscoTSP001.tsp and click Configure.
7) The Cisco IP PBX Service Provider window opens. Select the User tab and provide your CallManager username and password.
8) Select the CTI Manager tab, and provide information about the primary and secondary CallManager servers, either an IP address or host name. Click OK to close the window.
9) Open Microsoft Outlook and open the Contacts folder. Right-click one of the contacts that you want to call, then click Call Contact.
10) The New Call window opens. Click Dialing Options to make sure you are using the correct line to call.
11) In the newly-opened Dialing Options window, in the Connect Using Line area, select the line you want to use to call, then click OK.
12) Back in the New Call window, click Start Call. Call status shows as Dialing. At this point, the speaker on your IP phone activates, and you can hear the call progress.
13) When the call is connected, you see the Call Status as Connected. Closing this window ends the call. You can also end the call from the IP Phone, or by clicking End Call.
I hope this helps.
Regards.
