How to start running XML applications

[smahrous]

I have CCM 3.3(4) , I need to start implementing XML applications to my end users , Could any one tell me how to start , what application i need to install ..Is there any good documentation for that ..

Thanks

[dahringer]

Hi,

you can download the SDK.

This page describes the IP Phone SDK:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_programming_reference_guide_chapter09186a00801fb6dc.html

In the SDK any XML applications for end users. The documentation in the SDK descripe how the implemantate XML applications.

I hope it helps.

[aaronw.ca]

If you are asking about developing your own phone services, check out this thread:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dd63420

Here is the forum for XML service developers:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_messages%26mode%3Dnew%26location%3D.ee94c94

For pre-made XML Services, there are some in the IP Phone SDK, and this thread may lead you to others:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dd5f8ba

Hope that helps!

[RunCiplets]

Another alternative for phone service development is www.ciplets.com