Other Network Architecture Subjects

Not able to write configuration on Cisco3925E/SEC-K9. Its returning following error :- % Warning: Saving this config to nvram may corrupt any network management or sec urity files stored at the end of nvram. Continue? [no]: % Configuration buffer ful...

Save

Hi Guys, Could you please, tell me how can I send logs from the cisco devices to different syslog servers? for example: A Switch sending logs to 2 different syslog servers in different locations. Thank you

can i use this adapter? struggling to find supplier of cisco power supply in south africa Specification: Shell material: ABS+PC(Acrylonitrile Butadiene Styrene+Polycarbonate) Color: Black Input voltage: 180V-240V, 50Hz Output power: DC 48V. Output c...

Other side is Cisco firewalls and design is as following: Router 1 (.44) >> Leaf1_port1/20 (.41) Router (.45) >> Leaf2_port1/20 (.42) I am not able to trace/ping any of these IP from outside. Vendor is able to ping .41 but not .42, .44 (from .45). I ...

Hey guys, Anyone know the process of performing a license upgrade from ipbase to enterprise? I have Cat4507 R-E however their Sups are SUP 6L-E 10GE which I believe is already EOL. Can you share the commands needed and if its OK to proceed using t...

Hi, We have an issue in Cisco ASR 1006, randomly the adjacenys down. These adjacencys are configured towards CUCM trunk sip. In CUCM the trunks sip are  OK, there are not any logs  about drops of the trunk sips. Cisco ASR 1006 >> ASR1000 Software (X8...

Hi, i tried accessing the DMo User Interface as described in the official cisco Installation Manual (https://developer.cisco.com/site/data-in-motion/discover/getting-started-guide/#install-the-software) but was unsucessful  and the response was i was...

CAB-C15-CBN Cabinet Jumper Power Cord, 250 VAC 13A, C14-C15 Connectors The only part number that I can find is CAB-C15-CBN but this is 1m. Surely there is another part number for a 3m? TIA

Hi Experts, I'm having a challenge now in cisco Nexus5548, when I tried to insert single mode in ( 2   16    O2 16 port flexible GEM             N55-M16UP), Im having an error transceiver validation failed. But when I tried this to different module...

I recently came to know that Cybrary is offering free Cisco CCNA courses and certifications in this article. I am curious if Cisco or other Cisco partner employers will accept those certifications or not. Would like to know your opinions on this.

Hello, Could you please help me to validate this Design: Main site: Two IE-5000-16S12P (LAN base) Remote sites (13 sites): One IE-1000-4P2S-LM by Location Each IE 1000 switch will have 2 uplinks (primary and secondary link) to the two IE5000. About...

Hello All, One of our router was auto reloaded, Please help me to understand the cause of this and share the remedy to prevent.  Please refer the below logs---- router#sh ver Cisco IOS XE Software, Version 03.13.03.S - Extended Support Release Cisco ...