Other Network Architecture Subjects

Como puedo redistribuir BGP en dos routers conectados con OSPF, si el router que propaga BGP tiene la responsabilidad de dar a conocer las redes de ambos routers conectados a los extremos.Por su apoyo gracias.

Is reorder frame a concern in ppp multilnk connection? See output below, there are "5422515 reordered" which keeps incrementing every second, and there is a delay in connectivity. Just wondering if reorder is the cause, and what the reorder is? TY s...

Hello,Can somebody guide me as to how I can have my users dial into my Office Network so that they can attend to calls sitiing at home. Also is it possible for them to access my office network so that they can work from home itself.I think DID is a s...

Hi there, I got a Cisco 5350 with a PRI installed on it. My customer would like to separate the single PRI with two different dialing number for two different groups of people to dial in for data access. I have tried command modem-pool and called-...

Hi people:Can Somebody tell me if in a Remote access system (router 3620) which is working very well right now,can I deny a telephone number??, they are analog lines, it is like a ACL for phone number, is there a way to do that ??? software, or ward...

I have a router with a T1 frame-relay connection that im troubleshooting a VPN issue on. I dont think its a problem with the VPN box or the connection from the VPN box to the router, the VPN box diags and outputs are perfect and the connection is goo...

Does any one have experience on IMA with 4X2M E1 lease line?The case is thatLAN--3600 with E1 IMA----4XE1 lease line----3600 with E1 IMA---LANThe ideal is to increase the bandwidth between the nodes using legacy tachnology. Can IMA module use in that...

Hello,I'd like to know how I can measure the load charge of a vlan in a catalyst 6500 series. That vlan has a lot of different interfaces in it, with different speed lines. I'd like to know the % of load of the whole. I think that measure depends of ...

Hi people,Can a remote access router (cisco 2611) make a callback.It is in order to get sucurity in my system, can I do that??Do you know some example or links about.Thanks in advancedmc

HelloI am using 3745 router with 2 port Channelized E1 module with RAD HTU E1 CSU for Channelized E1 connectivity. I am using Cisco PRI-E1 cable.The problem is there is a indication of LOC ( it indicates the router CSU connectivity ) and it is showi...

hi all I´m using a catalyst 3750. First i defined 2 vlans, wich were assigned in the next order. -vlan 2 using port 3 -vlan 3 using port 5 After that i made a vlan interface (SVI) of vlan 2 and 3, with the next ip address --vlan 2 192.168.2.22/24 -...