Other Network Architecture Subjects

I would like to use Access Point which is controller based (AIR-CAP1602I-S-K9) and connect via cisco switch.They would like to use WS-C3650-24TD-S switch and understand that it willoperate as controller. My question is1.       Do we require any licen...

I am trying to create an etherchannel between two switches 2970G and a 3750G The configuration of the interfaces is as follows :interface Port-channel3 switchport mode access macro description 3750G-16TD!interface GigabitEthernet2/0/1 switchport trun...

I got a new license file for a router : (C880DATA-UNIVERSALK9-M), Version 15.2(4)M4I enter the comand : ro-nk-sildvik#license install tftp://192.168.20.10/FCZ173290NE_20140523045111898.zipI also tried the unziped file FCZ173290NE_20140523045111898.li...

I have a linksys/cisco router in my home, with a USB drive accessible to all users on the network.   The router is associated with a "smart WiFi" account, and I can access it over the internet with no problems, to view or possibly change the router s...

Hi,I have 2 switches connected with ether channel with a bundle of 4 linksMy q is one link in a switch fails or unplug then is there will be abu loop or error ?I want to know is it will be a problem 

hello,I am trying to communicate with my 2901 router with a console cable connected to a pc with windows 7 x64 ; wether i use the usb port or a serial port I get a message : unable to open port com, chack the port settings ;I've checked them and comp...

I have a setup as shown below.Internet clients --> Site A FW--> Site A L3 Switch -->L3 Switch Site B--> ServersSite B has a default route pointing to another FW at SiteB. I have to enable NAT on FW of SiteA in order in order for internet clients to r...

Attached is the config of a firewall we have. (External IP addresses changed to protect the innocent :-))We are able to ping using the ping command on the router, but devices on 10.10.11.x subnet are unable to ping, browse, or do anything.Can someone...

I configured my cisco WS-C3750X-12S-S with ip routing and it is working properly. i configured  a cisco  WS-C2960-24TC-S  switch and connect both switches via Fiber. each switches can communicate with other end. i can connect to C3750X from my local ...

 what does this Mean SW-CORE#show bootvarBOOT variable =CONFIG_FILE variable does not existBOOTLDR variable does not existConfiguration register is 0x2141Standby BOOT variable =Standby CONFIG_FILE variable does not existStandby BOOTLDR variable does ...

I'm not sure how long ago it happened at this point, but this issue started when I was hosting an online server for a game so I could play with a friend.All of a sudden, I lost internet connection, and did everything I could to get it back. I even di...

Hi,Please help. I'm trying to configure ipv6 in vrf on catalyst 4948E with ios ver. cat4500e-entservices-mz.151-2.SG4948-LAB(config)#vrf definition TEST4948-LAB(config-vrf)#address-family ipv6% IPv6 address family is not supportedIs there any solutio...

What is the standard warranty for cisco switches