Other Network Architecture Subjects

Hi!I have same difficulties of choise properly license for AS5350. I would like to use it as VoIP-gateway and as Remoute Access ServerNow I'm ordering the following:AS535-4E1-120-AC AC AS5350: 4E1, 120 ports, IP+ IOS, 120 Data Lic FR535-DAT2UP-LIC A...

Hello. I am trying to determine the summarized IP Address for the following range of addresses:172.16.8.0/21172.16.16.0/21172.16.24.0/21172.16.32.0/21172.16.40.0/21172.16.48.0/21172.16.56.0/21172.16.64.0/21172.16.72.0/21172.16.80.0/21172.16.88.0/21(S...

Is there a convenient way to transfer the routing entries for IP (e.g., SHOW IP ROUTE 10.0.0.0 or SHOW IP ROUTE EIGRP) from a Cisco router to Microsoft Excel. I want to sort the routing entries by gateway or by subnet.

Hello,I'm trying to forward VoIP data from the WAN to a LAN IP address via UDP & TCP ports using PAT. I've built the ports using the string below using the IP PAT PORTHANDLER command. The ports appear built when I use the SHOW IP PAT command, but t...

Hi,I have a customer using nGenius 1.3.0 Build 2.7 - They have a network of CAT 6 & 4ks with NAM modules installed into each of the 6ks. They have added all the CAT switches to nGenius Ok and they can add one NAM module but when they try and add a se...

Will Catalyst4507 be supported in future versions of CiscoView. What about ONT 1031?

Hi, I am having 3660 series router with 4 sync and 40 sync/Async ports.My problem is say taking 5th module, in that for S5/0 interface, after connecting any link giving Serial5/0 up but always line protocol down. In the same module connecting to ...

Hi there, I have several Catalyst 4000 Sup IV engine with IOS filename cat4000-is-mz.121-12c.EW.bin. From the release notes, we know that it does not support IPX standard and extended access-list list. May I ask whether it support ipx output-sap-...

Hi all,I config a dynamic access-list for dynamic control telnet access. But when I connect to the host (my host is 192.168.0.1), there is the following prompt:List#130-testing already contains this IP address pair[Connection to 192.168.2.1 closed by...

I have a 827 Router and have recently updated the IOS software to the following version: -c820-k9osy6-mz.122-2.XK2.binThe router works fine but I've lost the user friendly 'Cisco Router Web Set-up' tool. I can get to a different Web interface but it'...

does anyone have a link to a good cisco whitepaper on how to configure a router-router vpn? thanks a lot!

My customer is a school teacher , he ask me to config IP AND MAC filter function on cisco 4006 CORE switch and 3524 , 2950 , 2980 edge switch how do I config these switchs ?

Hi, I am trying to setup a cluster with 2 C3550-24-SMI switches and C2950-48-EI switch. I could successfully setup layer-3 vlans (with vlan ids numbered 2 onwards, withc vlan1 left as management vlan without any ip address) and the cluster with one...

I am new to the CLI-based switches and I am trying to find the command to save my running config to the sartup config (if needed).