I need to split my 24 56K modems (2x12) between to T-1 services. The controller T1 0 is using all 24 now and I need to split and have the 12-24 modems be used by a new T1 connected to controller T1 1
I can't get stat via this OID (SNMP report - "not found") 1.3.6.1.4.1.9.10.19.1.1.3.01.3.6.1.4.1.9.10.19.1.1.2.0Why? IOS IOS (tm) 3600 Software (C3620-I-M), Version 12.1(5)T5, RELEASE SOFTWARE (fc1)30 Mica Modem work with ISDN PRI.What IOS supported...
Hi anyone please clarify if I were to use the subinterface of ethernet ports(e0/0.1,e0/0.2...) in 2610 to conduct the ISL routing for few VLANs instead of using the fastethernet port, is it alright to that ?Maximum how many subinterfaces can be creat...
Hi anyone pls clarify as I have a Cat.4006 with a Supervisor Eng. II and a 6-port Fiber Module installed.I have configured an IP address to it by the following command;console>(enable)set interface sc0 10.0.1.1 255.0.0.0 10.0.1.255...When I used my I...
Hi anyone please help to clarify the following BGP routing;RouterA;s0 - 172.16.11.1e0 - 172.16.15.1loopback0 - 172.16.111.1RouterB;s0 - 172.16.11.2e0 - 10.1.10.1loopback0 - 172.16.11.2RouterA and RouterB are connected by different AS numbersAt Router...
Will IPM allow me to monitor the different types of traffic in my network? I am fully IPT at my core and branch sites. I also have mission critical Video traffic going to my branch sites. Can IPM distinguish between my Voice, Video, and Data traff...
Is there any way I can prevent certain domain users from accessing the vpn concentrator while allowing others (assuming they get there hands on the client software)?For example, with our old RRAS solution, we could go into Active Directory Users and ...
HiI need to create a menu system to run various basic admin commands on an AS5300. I need to do this without altering the normal telnet in vty access though. Ive got two plans to do this. 1) use the highest number vty to run a menu system, allowin...
Our organization already has an ASN and is publishing our IP network in the Internet. We have an internet access in our site 1 with three ISPs.Now we have to add a new site (site 2) that has two ISPs. We are are thinking about using the same ASN in s...
Hi !I am trying to implement callback-solution on a Cisco 3660 (with Cisco Secure ACS) as TACACS+ Server. A data-call is successfully established to the access-server - authenticated -and terminated - because of callback - the callback is initiated b...
How would I write an access list to inflate the default route received on one interface? I'd like to use 'offset-list <list_number> in 2 <interface>' but I'm unsure how to write a access list to do this (if possible)
Within our 3524 workgroup switches we noticed the inability to add another VLAN. Queston: Can we add another VLAN, i.e. VLAN 500, to be used for Management only, instead of using the VLAN 1?
Hey guys, I have two 2600's, 1 with (1) CSU/DSU and (1) Fast Ethernet port, and the other just has (2) FastEthernet ports. I'm in the process of getting (2) serial port modules for both of them, along with the required DTE/DCE cable. I have a good ...
We currently are trying to implement an ATM PVC to a remote office, using a pre-existing Frame-Relay line. We are using ansi as our lmi-type, but are unable to get traffic to pass. Both sides are up, and ATT verified the line is working. My question ...
