I have two 6500 and want to route traffic between them (notice, NOT trunk vlans or anything). Can someone confirm my steps. 1. Login to each Supervisor (6500) separately and create a vlan (set vlan 101 mychannel). 2. On each Supervisor (6500), set po...
I work for a small company that has a T1 circuit to the Internet. Network hardware is one 3548 Switch, Pix 506, and a 2610 Router.How can I measure available bandwidth for my circuit versus what I'm using. I'd even like to see the types of traffic ...
I have a 3660 with two ethernet ports. I would like all of the traffic coming in from our WAN to be routed to one of the ethernet ports(E0), even though some of the traffic may have a destination address that is the same as the other, directly connec...
I have a Cisco 1720 router with an WIC-1ENET card for the WAN connection.I can't get the WIC-1ENET card recognized.There are no bootup messages indicating a problem.It's installed in Slot 0I follow the instructions on configuring the card and go to t...
We have 2 WANG mainframes using 802.3 and I would like to pass the 802.3 traffic across a t1 link with 2 x 3662s. I've looked at STUN but it it not what I want. Does anyone know of any other solution I could try?
hi we are using 4500m routers as our wan routers, we are about to put in catalyst 6500s and segment our lan into vlans I have 6 10meg interfaces in the 4500's is there an advantage to using the 10 meg interfaces of the wan router (running eigrp) with...
Hi,We have two catalyst 5500 switches(actually one is cat 5513 andother one is cat 5509).I'm trying to patch(crossover) these two switches together.Cat 5513 has 9 ports gb ethernet module(ws-x5410) with SX gbic(ws-g5484)and 10/100 ethernet switch mod...
I am thinking of running Netware as opposed to Win2K...i don't need a webserver, it will mainly be a file server with internet connection sharing available...so would Novell Netware be a smart choice? I know of linux and Unix, but i want to learn th...
I need to configure a 5350 so that users on our network can dial out to different locations. I am looking for some config examples can someone give some pointers.Thanks
We have a backup link which we use only when our main link is down.As our Backup Service Provider is not running BGP, I have to run NAT when I have to use backup link.I have defined a standard access-list permitting all the IPs which are being used b...
HiI have many variables now relating to access-list im trying to block outside access to port 80 i need to start again and need to remove these entry's how do you remove them?????
