Other Network Architecture Subjects

can a switch do an RARP when the switch IP is configured as the gateway on the server...thanks

Here is one for ya...Couple weeks ago comcast comes by cause I am not getting the speeds on my home broadband connection that I expected. When testing straight out of the modem we were getting 8mb down, bout 768up. Out of the wireless router (Links...

I have setup a VPN between a 3030 Concentrator and PIX. I need to allow an entire subnet behind the 3030 concentrator to access 2 hosts behind the PIX (i.e. initiate connections to the 2 servers behind the PIX). I do not want to allow the 2 hosts b...

Anyone seen a stack of 3750-48PS-S's reload when the master fails? We have a few stacks, each with 3 identical 3750's in the stack, and when the master switch (switch 1 priority 15) was powered down, the stack crashed and reloaded. This only happened...

I have 4507 with sup iv and proper software with ospf support. I have enabled ip routing on the switch and configured ospf but it is not sharing ospf routes with its neighbours. Through debug i saw that it is recieving updates from its neighbors but ...

HiWe have a cisco 5509 with the RSM module and 2924xl for l2 switching. We recently noticed that some of our users have a wrong default gateway setting but can still surf. I fail to understand how that can possibly work but I can assure you that it d...

What is the difference between "end of software maintenance releases" and the "last date of support" statement when you look at the EOL information .

We have our 6509 on upc power back up but everytime we have power outage my 6509 has stops responding for at least a min and we get down pages for the vlans configured on MSFC. Has anyone seen this. I'm running cat6000-supk9.8-1-3.bin on SUP and c6ms...

Can anyone tell me if there is any difference really between natting my web server and port, rather than just natting the ip of the web server and using an access list to only allow http traffic to it ?

hicould you pls help me, I have 2610xm but I this router has not encapsulation command. do you think that 2610xm can not support encapsulation?thanks

Hi;I've moved a WIndows 2003 server from a dumb cisco switch to my 6509 Catalyst. Since doing this, I'm experiencing a wierd issue in that:HostA= Windows XP client 198.177.133.61/24HostB= Windows 2003 Server 198.177.133.12/24Ping from HostA to HostB ...

I will appreciate any help about the below subject.- there is a catalyst 2960 switch with 3 VLANs configured on it: VLAN 1, VLAN 2 and VLAN 3 (VLAN 1 is only for management purposes).- the 2960 guy is attached to another catalyst with trunk port.- ha...