Other Security Subjects

I am having trouble getting an extended access to work. I am wanting to apply the ACL to a vlan A. Vlan A needs access to the Internet and a several servers in another valn, vlan B. The problem I am having is how do I allow access to just the DNS,HTT...

When the firewall boots, I get a message about conflicting statics. Despite the message everything seems to work as expected. Maybe I'm blind but I just don't see it:static (inside,outside) tcp interface 3389 192.168.0.250 3389 netmask 255.255.255....

Please consider the below configuration, which shows only relavant commands to my inquiry. DMZ host 172.20.1.44 will nat to a outside global pat address if ACL WWW is matched or will not nat of the destination is a VPN destination network. Currently ...

Hi,since 2 weeks i get an error when i try to install the certificate of my ACS on the client.i tried the automate install within the cta. also tried the manual install with ctacert. Both methods end with an error.There no entries in the log. Also no...

Hi,I have tried to initiate a traceroute from one router behind my PIX 6.3 to another router somewhere in the outside. When I use "debug packet inside" there was display but when I tried to use on the "outside" interface I cannot see the debug output...

what's the default priv level on firewall and how can it be changed..

I wanted to find out if there is any way to indentify which clients on a particular network interface are using a certain amount of bandwidth. We have an ASA 5510 with four interfaces including the internet and one network is generating an excessive ...

All I am trying to configure port-sec on the 6509 and I am unable to execute the stucky command. Would it be poosible that the IOS revision needs to be update? Here is the IOS eversion I am running.12.2 (18v) Sr2POrt-Sec Config:interface GigabitEth...

Folks, I was looking at the user guide for Mars and it talks about integration with NAC. Can i integrate MARS with clean access solution from Cisco or do they mean integrating MARS with ACS(framework). It is very useful if integrated with CCS.?

I'm working on a Clean Access design for a small college. Does anyone have any good resources for design, specifically for supporting approx. 1000 users? I'm also looking for part numbers but have only found one so far.Thanks!

I just upgraded my PIX-515 from 7.0.4 to 7.1.2 (with ASDM 5.0.4 to 5.1.2) and WITHOUT making any changes to my current basic working configuration I began noticing ...• that MSN Messenger 7.5 stopped working competely (error 80048820, We were unable ...

I am in process to convert Checkpoint FW to Pix 515 FW, I do not know how to allow the following Services in the PIX:MSExchange-RemoteAdmin, MSExchange-SiteConnectorI can not find the port for these Services. Please help.Thanks.

how to set the management ip for a firewall say like we have a loopback int for router,switch..