Hello,I'm trying to tunnel traffic from an "outside" network to an "inside" network. The "outside" network is a trusted device due to our topology setup. I see that the CONDUIT command is not used on the FWSM. Is there an alternative? For example...
Got a PIX 515E with 4FE card. Have machines in different DMZs. Have Windows Active Directory domain controller in one DMZ. Can the other machines belong to this single domain (obviously if I open the necessary ports) bearing in mind that the machines...
Hello,We have PIX 515 with Version 6.3(3). We are planning to setup Video conferencing to have a conference with our international customers . We are planning to put the Video conference system behind the firewall for security reasons .I would apprec...
Hi we keep seeing this type of message on our firewall logs; I’m not 100% sure if it's anything to worry about (is it just a SMTP command the PIX doesn't know?)Critical 192.168.1.1 %PIX-2-108002: SMTP replaced l: out 212.125.75.19 in 192.168.1.25 dat...
Hi,i would like to monitor all events generated by IDS sensor without using cisco monitoring tools but my own one is it possible ? i saw that CSIDS uses prorpietary protocol for sending log events to server sensor. my aim is to intercept these event ...
Our sensor is sitting behind the firewall with natted addressWorkstation address 10.1.1.1 is natted to 192.1.1.1 before hitting the sensor.Sensor address 10.20.20.20 is also natted to 192.20.20.20 before returning back to workstation.No problem pingi...
Hi,In my organization there is team in charge on networking and other team in charge on security.My questions are:1. The networking team should manage all traffic throw the MSFC (IOS), how can I be sure that they will not be able to make any changes ...
I have VMS server version 2.2. Under Server Configuration>Connectivity Tools>Process Failures> on the right hand side I always have this error message [the IDS_DbAdminAnalyzer is fail to start].Then I have to restart the process from Process Manageme...
If I have access-list and ICMP statements on the same interface, which contradicts each other, who gets the preference. for ex. If I deny a packet in icmp and permit the packet in access-list, who wins.
I know this can't be a difficult problem, but this is a first-time set up for me; I've been setting up multiple IPsec connections from 1710 routers to our 3000 Concentrator and this is the only 3002 hardware client of the lot. I'm getting a phase I e...
Anyone got any advice/links for Best Practice for using CSA with Windows Update. We have CSA up and running fine, but Windows Update on the client machines is causing grief, as each time the download might be a different filename or in a differnet ar...
My cisco work (v1.2.3) can't defect my IDS (4215) with IOS 4.1 (1) S47. so that I can't config IDS with ciscowork??What Can I do ??? I am a beginner of IDSThx for your help
