Dears
I have two link working Failover throgh BGP by using weight command , i need to allow all traffic for spacific host inside the LAN by using the backup link which has less weight
Kind Regards
Hi Sorry if this is a stupid question,
I am looking to query IPv6 Prefix Deligation->Cable Modem MAC via SNMP on a Cisco CMTS UBR 10k,
I've tried some OID's from the IPv6_MIB without success ... would anyone knoe which MIB/OID I should or could use ?...
hi - we have an ASR 1002 configured to be an LNS: when we use the following RADIUS AV Pairs:cisco-avpair="ip:ip-unnumbered=Loopback 13",orcisco-avpair="lcp:interface-config=ip address 16.16.45.41 255.255.255.252", We get the following message and the...
Hi I want a solution regarding the below metter. I have a cisco router and 2 ISPs internet connection. I run a mail server running in a private ip address(fixed). NAT redundancy is already configured and running smooth but the issue is that i added a...
any known bugs in the version 3.6.5 while redirecting a user to a website?the IE is indicating websitefound and waiting for reply with a blank page.the package is configured to block all flows and redirect the user to a website..
How do you get round this when trying to specify devices for dhcp based on MAC address
mac access-list extended RUCKUS
deny F0B0.5200.0000 0000.00FF.FFFF any
deny E010.7F00.0000 0000.00FF.FFFF any
deny D468.4D00.0000 0000.00FF.FFFF ...
On an ASR1001-X, I tried to limit the rate of a subinterface and apply priority on specific traffic.
But I can't apply the policy on the subinterface.
Is there another way to do it. Without the priority level 2 it works.
class-map match-all Class-C...
HI
As according to the customer requirement, i have coded to the following. Please see attachment.
Traffic is fail over and some traffic going with the seconary SP (SP2)
But if HQ SP1 link fails, since i have set the local preference in branch, sti...
Hello can someone please help me. I would like to ssh into my switch outside of my network. When am on my network I can telnet and shh into my switch just find but how do you ssh into a swich off my network, if I have a commerical router like verizon...
To full above brief description, i have added following configurations
Green color with brackets are for coments
1. Branch :
sho startup-configUsing 2116 out of 57336 bytes!!version 12.4service timestamps debug datetime msecservice timestamps log d...
I am working on getting timing information from a SSU 2000 to our ASR 903 chassis.
I find that I do not know how to configure and validate this and so far the documentation is not too helpful to me.
Here is what the documentation says to me:
When...
This is a brand new chassis with brand new cards.
I am not finding any documentation that describes this problem or how to correct it.
Any ideas?
The only thing google is finding is a dead link
"16 x T1/E1 Interface Module (PN: A900-IMA16D) ..... I...
