Routers - Small Business

I have a Cisco RV082 that doesn't appear to filter any selected categories. To run through what i've done so far, within the 'Web Protection' screen i've:enabled URL filteringconfigured a number of categories to filter by putting a tick in the repect...

We have an RVS-4000 router that we use as an Internet gateway on our school network.  I am trying to set up an Internet Access Policy to block some specific websites by URL using a domain name.  I set up the policy, and added a PC to the list using t...

I am trying to spec out these routers as teleworker routers to establish IPSec VPN tunnels from private residences to the HQ where the Cisco Small Business series firewall SA541 will be located. So, I am looking for one IPSec VPN tunnel between each ...

Hi!I'm using two WRV210 Linksys Cisco Routers to create a tunnel between two places with a pppoe adsl internet connection.I made several tests with new 2.xxx and old 1.7xx firmware, and nothing changes.Try to reset to factory defaults, and nothing ch...

Hi,I have a WRVS4400N, and need to apply access control to an IPSec tunnel that terminates at a client site, but can't seem to make the device comply.I can configure ACLs on their device for the LAN to restrict packets coming back into my network, an...

Hi,We have just acquired a Cisco RV120W Firewall Router and we are experiencing issues with this router. I've read some threads related to port forward issue with RV120W before writing this new topic.We have 2 locations (site A and site B) connected ...

Howdy,I got a RSV4000 router here with the latest firmware 1.3.3.5, trying to get the quick VPN client to connect.As far configurations go I have under WAN set the IP, subnetmask, DNS1, DNS2 and gateway. And under VPN I have created a client account ...

we have recently installed a RV042 V1.3 in our office and have been having a  very frustrating time with internet access. It appears to be a DNS issue and is  certainly the RV042 with the issue. When I connect directly or through our old  Linsys 54G ...

I am trying to set up my router to grant http traffic a minimum banwidth of - for example - 5,000 kBit (if there is any http traffic).So I set http min. rate to 5,000 while I set nntp min. rate to 1 (see enclosed screen shot)However, when I run nntp ...

Dear,My RVS4000 router freezes up when a lot of data is being pushed through the Ipsec tunnel. Let me explain in detail.On physical location A, I have an RVS4000 router (with IP 192.168.3.1) which is permanently connected with a WRVS4400 router (with...

I'm using RV016, and recently i activated the Protectlink Web, since then i found out the performance of the web surfing very slow, and i tried to checked system log and i noticed a message Warning! ProtectLink URL queue is almost full (80 percent) n...

I just purchased an RV042 Dual WAN Router. Both WAN's are connected from different ISP's. I have a PBX phone server connected to this router and want all traffic to and from this phone server going out strictly on one WAN and all the computers and th...

Hello,I recently purchased this router and after many issues I finally have it working.  Sort of.The reason why I purchased the router is the following:I use a site that authenticates via IP address (I have a static IP) rather than just username/pass...