Routers - Small Business

Hello, I have a RVL200 Router ,and I encounter issue related to remote management. The problem with the router appears only with specific configuration which I accurately describes below (You can also download attached configuration - login:admin pas...

Good morning.we have a T1 installed at our site and recently purchased a broadband connection from a different ISP. Our plan is to utilize both ISPs  to Load-balance our Internet and setup auto-failover in case either one fails.  We run exchange 2007...

I am using a power amp on this ap, and wondering if you could turn off the other two antennas?

Hi. I recently bought a new Linksys RV082. I have 2 ISP (one Cable modem, one xDSL) and connect the two providers to the respectives WAN1 and WAN2. No matter which equipment I connect to WAN2, the router does not find any IP given by the ISP equipmen...

Hi everyone, I have a RV042 and very happy with all features except the QuickVPN setup. I use PPTP and everything works great... I use QuickVPN and it hangs on "Verifying Network". I have read every forum post relating to this and still i can not get...

Hello all,     I've got a pretty typical setup with my DSL modem hooked to my WRT54GS, which is the gateway for my home network, both wired and not.   I have received a block of static IP's from my ISP and I now want to build a DMZ in "front" of my h...

I am looking for a good client software so I can vpn into my home and office RV042 VPN routers from the road. I need one that will work on both XP32 bit and XP64 bit. I have tried the Quick VPN off Linksys web site but it seems to have problems on th...

Hello, Till now I work only with router 1800 and 2800. I would like to know if some of you have some experience in configuring a router 520. What I want to know if with this router can I realize this scenario:- 3 Vlan: vlan1, vlan2, vlan3.- 3 Lan: 10...

Hi there,I miss a bit of documentation for the SR520. We could not configure our internet connection through the CCA so we did so through the IOS CLI. But now the CCA keeps crashing when we look at the SR520.What is the smartest CLI way to setup to S...

I have been using CCA 2.0 and configured the device based on documents (a recurring story) and well it wont work...... again.This is the results of the 'show tcp brief'SR520#show tcp brief allTCB       Local Address               Foreign Address     ...

RV082 ddns does not update automatically. When you go to the ddns tab it states:"DDNS is updated successfully." ,but in actuality it does not update. After 30 days, DynDNS.org sends me an email stating that my account and DDNS have not been updated a...

Has anyone been successful with this setup, if so explain configs? I assume there is an capability issue but I don't have proof. Is there any known issues that i'm not aware of?

We have installed three WRV200 with FW 1.0.39 on very different locations. Internet access is ADSL. Routers work fine until there's power loss (due to thunderstorms etc). When power is restored, there's no internet connection re-established. If we re...

Does anyone know of any issues using DHCP relay through a WRVS4400N V2? I have found that there was an issue in V1 but have not seen a fix for it. Has this carried over to V2?