RV260 LAG to to CBS-250-16

bryand83 · ‎07-04-2021

I have the latest firmware on both my switch and router.

I have two patch cables between the router and switch and a LAG configured to bond them. I cannot get from active/standby to active/active even though I've been able to configure active/active on other LAGs on my network to other devices. It is something that the RV260 doesn't support?

marce1000 · ‎07-04-2021

- Apparently it should - ref : https://www.cisco.com/c/en/us/support/docs/smb/routers/cisco-rv-series-small-business-routers/kmgmt-2482-port-settings-RV160-RV260.html

Check Step 11 in this document, also is there anything in the logs when you try to 'activate' the intended lag-configuration ?

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

balaji.bandi · ‎07-04-2021

Can you post a screenshot of the LAG config from RV, and show run from CBS from cli.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help