Routing

Hi, We have some CISCO 1921 with IPSEC VPN and DMVPN Tunnel. We have around 18 IPSEc Tunnel with Netgear Router. When I Turn the Power Switch OFF and Back ON the Router take Around 15 Minutes before the Computer in the network are able to Access the ...

Good morning, I have a problem with a Cisco router 2900 series, I have to connect from outside (other location in another country) with Remote Desktop connection port 3389 to an internal IP address ( a server). From any IP address it have to permit ...

Is 15.6(3)M0a available to the public (registered users) for use on 2921/K9 routers?    The 15.6(3)M0a version is suppose to fix a security vulnerability.  The latest version I am able to find is 15.6(3)M. Thanks.

I am trying to connect my Cisco 887a to a new BTInfinity connection using a static IP. The line works fine with the BT supplied hub but I cannot seem to reach out to the internet when I try the Cisco 887a device. I am new to routing and Cisco device...

Hi, I have Cisco  WS-C2960X-48TS-L and I want to delete/Disable IP host-routing but I failed. Once I do no ip host-routing in global mode, it removes but i lost Management IP Reachability of Switch and then I will have to apply this ip host-routing a...

Hello, I need to measure the percentage BGP peer uptime per month on a Cisco router. is there a MIB entry that I can poll via SNMP to find this out ? - or what would be an alternative method ? Thank you kindly.

I was trying to use my console port as a second serial connection for i only have one serial connection and need a second one. I read through a lot of staff could get it any where.  Any ideas would really appreciated. 

I'm trying to enable site-to-site vpn on a cisco 5506-x. I'm getting an error I don't understand: [ERROR] crypto ikev2 enable outside     Failed to open "udp/localized/2/4500" ERROR: Error opening IKE port 4500 on Interface outside Any ideas?Thanks, ...

If I have a policy-map that uses 10 different classes but my "priority" class is located at the bottom, is it still scheduled first within an interval?  I would assume it is, but I'm confused because I know that policy-maps are processed in a top-dow...

Hello, Could anybody explain me about sh policy-map control-plane command on c6500? I'm implementing CoPP on my cisco switch. I've created ACLs, class-maps and policy. After that, I entered sh policy-map control-plane CLI command: #sh policy-map con...