Routing

Dear All, I have problem with below log which I believe is the cause for the CDP neighborship's bouncing that I'm seeing in several interfaces of this ASR9K. Please advise the solution. Thanks in advance. LC/0/0/CPU0:Oct 18 12:47:38.976 EDT: pfm_no...

Greetings, I have a 2911 router that I'm trying to configure SNMP on, but having problems with one command: snmp-server enable traps voice poor-qov. I'm thinking that maybe the command has changed or isn't supported, but haven't found anything specif...

Hello. How to make slow or dificult a lot the web of the others users in a domestic home wi-fi network for some time? (create a considerable dificulter, bodersome, for example, a big delay or to limit a lot the bandwith) 1 desktop, 1 notebook e sever...

Hi,   I have some confusion please see the below packet tracer snap and topology table metric of 10.0.2.0 network from R0 P 10.0.2.0/24, 1 successors, FD is 3072 via 10.0.1.2 (3072/2816), GigabitEthernet0/0 via 10.0.0.2 (2170112/2816), Serial0/0...

We are experiencing an issue where a Site-to-Site VPN branch office is able to communicate with our CUCM Publisher (192.168.1.x/24) residing on an MPLS network on the backside of our data center switch, however, it cannot communicate with the CUCM Su...

i have 1 question that i really curious about: What happens to a route if it does not match any statements in the route map for redistribution? can any one help me out? thank you in advance!

Hi,I am facing a problem where my TenGigE interface is sometime down.Diagram:ASR1K <----> ASR9KLog on ASR1K :.Jan 14 07:56:31 GMT+7: %IOSXE_SPA-6-UPDOWN: Interface TenGigabitEthernet0/2/0, link down due to remote faultOn ASR9K, i don't find any log.B...

hi to all, i am trying to configure my new router to connect to cable modem on FA3 the connectation need to be as DHCP client. as i understand it right i have to work with vlans so my inside network is vlan 10 interface FA1 192.168.1.0/24 dhcp is ena...

Hi, this router cannot accept HTTP connections from any browser type, even trying on different operating systems as well. This appliance has been in a box for a long time and never used, till yesterday when we fired it up. We installed CPPExpress Adm...

hey please i need to help , i try to install modul EHWIC-D-8ESG-P in router cisco 3925 but this card is not detected . cordialy

Hi All, We have a remote site that is experiencing garbled voice issues that appears to be pointing to QoS.  The set-up of the network pre-dates me, but I noticed that we have two Cisco Edge routers (one with Class/Policy Maps and the other without),...

Hi everybody.I have a multiVRF CE with 1 additional VRFs configured.My need is to permit the connectivity to the local loopback (that must be on the global routing table) from to the networks coming from the additional vrfThe configuration is somethi...