Routing

web have a cisco 3825 router with two gigabit ethernet ports and a SFP port at same timecan i make use of two ports or only one(SFP or Gig0/0) port

Hi Community,Scenario: HQ WAN Router already has a QoS Policy applied on its WAN port (30M link) [HQ has several branch sites and no issues with the rest of them except one branch. That one branch will be spoken about in this thread]Branch WAN Router...

Hello Everybody,I have a special Network Architecture , where i have a stable and realiable wirless Network That works in Layer2 and this is my main Network to connect my remote location to the Hub, and at the same time i have an IP VPN over MPLS Net...

Hello Everyone,Thank you all in advance.  I have a Cisco 3750 router that is currently on IOS 12.2.  This router serves as our VOIP gateway, and sends and recieves tons of faxes.  We use the XMediusFax server.  It works really well.  However, as of l...

We have a Cisco 2851 router that crashes every night. Below is the 'show log' output. The provider is telling us that it is our equipment. We have replaced the router and still have the same problem. Is it our equipment or the provider? Please help.F...

Hi folks,This is a repeat question can't find the original thread but did find some other threads asking a similar question. Most pointing back to some configuration notes or another thread that describes a similar configuration of which neither quit...

Hi All,I want to know if the Cisco 2900 series can do UC without having to buy any other hardware.I read through the 2900 series datasheet, and i can understand it does.But will want to clarify if i do not need any other hardware except the Unified C...

Hi,We have a client with a Cisco 887 router using it on a Plusnet ADSL service.Internet browsing and all other functions are working as they should, except outbound emails.  The client is using a private hosted mail server for their emails and can re...

I am getting ready to deploy IP sla with policy based routing. I feel pretty confident that my IP sla and PBR configuration is correct, although I attached their configuration to the bottom of my post. My question is with the NAT statements; as long ...

Why can't I use the interface commands:  tunnel bandwidth transmit -and- tunnel bandwidth receive     commands on the below platform and IOS? Router#sh hardwareCisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version 15.2(1)T1, RELEASE SOFTW...

Hi ,could you people suggest on below.We have two offices in differrent locations and these two offices  has connectivity through MPLS cloud.For exampls :Location A  advertising the below NW in MPLS10.10.0./2410.20.0./2410.20.0./24Location B advertis...

Good morning at all, I m new in the forum and I will thank everybody can answer me at a question on route summarization.I don’t understand the difference when to apply the ip summary-address on interface or when to apply at protocol level. If I apply...