Routing

Hi, we currently have an mpls network setup (where everything runs into our switch stack) and are going to be moving two of the sites off the mpls over to a p2p connection.  All of our mpls sites are currently setup with the same 2 vlans 192.168.41.x...

Hello, I'm sorry but I think this is going to be a long post....I have a problem accessing some IP addresses in my network and I think it is related to my router (a Cisco1841).I can assure everyone I'm at the point where I think nothing makes sense a...

We are building an infrastructure for hosting at a shared data center.  The goal is to have redundancy throughout the infrastructure.  Can someone please take a look at the rough draft design and give any feedback (good or bad)?The goal is to have mu...

HiI have question related to OSPF Router Priority.What will happen to the election process when all the routers in the NBMA has zero proiority. In other words, will OSPF converge if DR and BDR goes down and the rest of the router in the system has pr...

Hi,I am not sure if this is the right location to ask these questions, if not please lead me to the right one.Under the Network Diagram section of the Filtering on Cisco IOS Router document (http://www.cisco.com/application/pdf/paws/110318/ciscoiosur...

I need to setup a fips 140-2 compliant tunnel. We have a 2621XM which is on the list of compliant devices. But, the required ios image 12.3(3d) is no lonager available.Any suggestions on how I could obtain this specific firmware version?

Hi ,I am seeing input drops between cisco 7200 and cisco 6500.Drops are increasing continuosly.input queue: 0/1000/1512/0 (size/max/drops/flushes) total output drops=0.I have already increased the hold queue value to 1000.

What is an X.25 interface?

In our proposed design, we will be hosting VM's at our DC, and using our Corp office as the redundant path.  We are peering to the same ISP and splitting the /24 into two /25's.  The two offices are connected via 100MB Metro Ethernet.  I am unsure of...

My BGP route has 2 routes for a networkcore-pri#sh ip bgp 8.3.26.0/23BGP routing table entry for 8.3.26.0/23, version 245129772Paths: (2 available, best #1, table Default-IP-Routing-Table)  Not advertised to any peer  65535 3356 26769    10.1.1.2 (me...

Hie Mates,I recently bought a Cisco 1841 Router to replace a 1605 router. I copied all the configurations into the new router. Everything else is working fine abut now with the new router I cannont access the internet. I use Optic fibre to connect to...

Is there a way to set the MTU size for an ADSL connection using an ATM card?Current output is as follows:ATM0 is up, line protocol is up  Hardware is DSLSAR (with Alcatel ADSL Module)  MTU 4470 bytes, sub MTU 4470, BW 832 Kbit, DLY 610 usec,  

I had to use a console cable and confreg to break into a router that I copied a new config into.I saved the current config to a TFTP server, made my changes (we were swapping ISPs so just changing IP addys), and once I did "copy tftp startup", I was ...

Has anyone been able to get the RVS4000 working with a static DNS provider (OpenDns for example)?  I've setup the DNS entries on the LAN side; however, the DNS values are defaulting to what my provider (Cox) offers.  Any assistance would be greatly a...