Routing

Hey guysIn my CCNP study lab I have a couple 2502's that I'm trying to connect with a back-to-back serial cable. Got a clockrate configured on the DCE end, they both have ppp encapsulation configured, except the line protocol isn't coming up. It sa...

I have two routers each connected to an MPLS network with multiple T1's using multilink. The configuration for the multilink on the two routers is different.Router A interface Serial0/0/0:0 description MPLS no ip address encapsulation ppp no ip rout...

Hi,I am planning to run the EIGRP in my netowrk. Here is my requirements.1) A,B,C,D,E locations connected to SP VPLs (full mesh) 2) A,B,C,D will have full routes of each location.3) If any body wantS to communicate to any location, he shOULD contact ...

I have a small network with one router and three switches. I would like to router to be an NTP client to a public NTP server, and then have the router be the NTP server for the swtiches. I also don't want the router to respond to NTP queries from a...

Hello All, I have a 7206VXR router. I have a small confusion with the bandwidth points that I am getting when i Give a show vers.show version (chopped): Cisco IOS Software, 7200 Software (C7200P-IPBASE-M), Version 12.4(4)XD10, RELEASE SOFTWARE (...

Hi I have a 2511 Cisco router which I should downgrade it's IOS version to support IS-IS from c2500-is-l.123-26.bin to version c2500-js-l.122-24a.binwhen I used copy tftp flash command the router successfully reload and try to start the copy process,...

HI Netpro:my question : can I use wic-2t and vwic-e1/1t to make Multilink on C2821.thanks a lot zhouJJ

Dear All Expert,I would like to ask all of you...I had connection VPN HQ to branch already( i mean it is working) but the branch it cannot access internet so i would like to allow all the branch office access internet from my HQ. but at my HQ i had ...

I am having a problem with my ACL configuration on a 1720 router. When users try to surf with the following ACL they get blocked:ip access-list extended PERIMETER permit udp host 17.29.14.73 host 21.31.116.209 eq isakmp permit esp host 17.29.14.73 ho...

HiI have the following setup:LAN1 with DHCP server 10.20.30.253 & Internet server as gateway for LAN with IP 10.20.30.254. Both are on the same subnet.I have a remote site LAN2 which is getting DHCP from LAN1. That is working fine. However I need to ...

What's happening is that, i have a cisco 1801 with about 5 Vlans, im having problems on my voip vlan, like, 2, 3 days ago, 3 of my phones(2Cisco, 1 Grandstream) started having issues, i can make and receive calls, but i cant hear anything, neither ca...

Here is the configuration.interface multilink 1 ip address 192.168.249.101 255.255.255.252 encapsulation ppp no peer neighbor-route no cdp enable bandwidth 3000 ppp multilink fragment disable ppp multilink group 1 ppp multilink links minimum 2 mandat...

I am on a fact finding mission in regards to becomming dual homed to the internet. I currently have a registered ASN associated with my own Class C address space with my primary provider located at my corporate office. I have a secondary provider at ...