Routing

I am replacing a nortel router provided by verizon with a cisco one. The connection is a bonded Frame Relay connection of 3 t-1s. I think i have most of the setup right but am unsure. I appreciate any help! I have attached the relevant nortel config ...

Does anyone know where I could find more information about this design option: Single DMVPN Cloud Topology?I've looked in the DMVPN design guide and i need little more info.Thanks

All,I've been working on this all weekend, and I can't figure out what's wrong. My requirements are that I'm about to bring up a tunnel on demand from one host inside my network to my office for only certain subnets. I've got control of both sides ro...

hallo I have a cisco1841 IOS 12.4(15)T8 with a HWIC-2SHDSL card in slot 0.It is connected to a 4-wire, annex B, 4096kbps shdsl line.If I disconnect the shdsl cable the hwic does not resync !!!!I must shutdown and the up the shdsl-group to resync.The ...

I usually creat a vlan via the following commandsSwitch(config)# vlan 2000Switch(config-vlan)# However, what difference is there inusing the vlan database command?VLAN Configuration ModeYou can use the VLAN configuration commands to create or modify ...

Why we need Vland Group & what is the benefit of assigning VLan in that Group. Please help.Router(config)# firewall vlan-group 50 55-57Router(config)# firewall vlan-group 51 70-85Router(config)# firewall vlan-group 52 100Router(config)# firewall modu...

Hello, All!I have problem with RSPAN monitoring session over multiply switches.My configuration is like this:|catalyst1 2960|---|some switch1|---|some switch2|---|catalyst2 2960|catalysts is under my control, while some switch 1 and 2 under control o...

Hi,We are using 2811 Router with VIC3-2FXS-DID Module.But we are not able to configure this FXS module. In Show inventory,we can able to see the module,but not able to configure.For this we require PVDM's ???Please help me out!!

Hi I would like to know what the following means:ip auth-proxy max-nodata-conns 3ip admission max-nodata-conns 3Is this a part of Cisco IDS? Can this cause TCP resets to the source if itdetects a signature that does not comply with security policy? P...

Dear All,I would like to ask you some question that on Cisco switch,Router and ASA how can we know that loop cable in those device and which command that we can show? and how can we now a virus attach on device?Best Regards,join

i want to cover a site by using HWIC-3G and i asked my service provider about this service and he told me that he will give me 1.8 Mb/s for download and 384 Kb/s for upload . i see that this speed is low specially that i will use video conference aft...

After few weeks the unity stops working.The Ip phone gives busy signal.When i restart the cisco unity server it starts working.I don't know the cause of problem.Please help!!!!!!!!

I have a T1 that is handed off with ethernet. I need to do QOS on the line for bandwidth sharing of two servers. Ihave configured the fa0/0 with a few policies but they all seem to be using the 100mpbs to base the QOS on. I have set the bandwidth com...