Routing

RIP can carry 25 routes by 1 update and what about other routing protocols?FOrexample OSPF?

Sourece :I have 2 routers to 2 ISP's (Internet) connecting to 1 ASA (LAN).Dest: 1 ISP Internet and pix506e. Want to build a tunnel form source to Dest, even if 1 ISP is down @ source.

Hello,I was hoping someone could assist with providing me details or perhaps a link where I can find the default configuration settings of the VWIC2-2MFT-G703. We are trying to determine - the out of the box - default behavior of this module and wha...

Hi all,could some one explain me how eigrp neighbors form. for ex. i have 2 routers and 2 l3 switches interconnected dia enclosed.

Router A: This is the primary Internet gateway. To get the failover working I'd like to forward all the Internet traffic to a Remote Router BRouter B: This is the secondary Internet gateway. This router is connected to Router A via 5 hops.Now, How ca...

Hello All,Most of the documentation I can find on "Pending routes" from show ip eigrp interfaces comes directly from Cisco and is not that helpful.Their definition is "Number of routes in the packets sitting in the transmit queue waiting to be sent."...

Service provider has given 45Mbps link as ethernet. When there is no load on that link reliability is good(255/255). if there is atlease 1Mb on link reliability is varying 245/255. What might be the issue.

We have recently upgraded our Internet connectivity from our data centre to include a 3rd peer with full Internet routing tables. Since then we have experienced a number of issues with routing loops on our core network. Inspection of the problem show...

have router ip 172.16.9.1 and my system ip in 172.16.8.1. i cannot access my router and other network of 172.16.x.x.only access router when my system ip 172.16.9.x. what configuration can make the router can access with all subnet of 172.16.x.x

I have a 2611 router connected with a dynamic ip assigned by the ISP. My configuration works fine for now but when I get a new ip assigned from my ISP I know my port forwarding will break. For some reason I cannot route-map to the interface fa0/0 i...

Hello,Please note, that I'm a newbie in Cisco networking. Just started with an ASA 5505 an can get quite well with it, except that I want to upgrade the ASA and the ASDM. I understand that the versions of the 2 are interconnected with each other.The ...

Hi,I've got my main campus dans a remote site connected with a GRE over IPsec tunnel in tunnel mode. The GRE/IPsec works just fine. My problem is with my outbound policy-map. This one is used to police the traffic to the Bw of the remote site. It got...

One of our ISP clients, needs to control their outgoing and incoming internet traffic accurately. Currently traffic upload (outgoing) is controlled by implementing PBR since this ISP doesn't receive any BGP Full Routing table from any upstream and th...