Routing

HelloI have a 4 networks and I will connect them with OSPF network.I need to know more about redistribution with details and examples.Do you know any book and documents that you can recommend.RegardsErsin

Hi all. I have a pix 515 with 6.3(4) ios. The pix is connected to my office/dmz/internet networks. Due to some sql requirements, the web server on my dmz network is allowed to access my sql server on office network. My web server is using ip 192.168....

Hi,Can anyone help me to resolve this issue.My router Cisco 1751-V taking 10 minutes to boot.Which has 32 KB RAM and 32 MB Flash.Having the following IOS c1700-sv3y-mz.123-2.T.binThanks and Regards,Lavnaholy

s1(BGP) s1 (eirgp) s0(eirgp) e0---->>RouterA<<---------------->>RouterB<<----------I connected one interface BGP and another interface is eirgp, am unable to ping the router Ethernet from routerA after configuring the redistribute bgp 6500...

Hi All,I would like to know which IOS version higher that I listed out below.1. Version 12.3(7)XR32. Version 12.3(2)XC XR3 and XC makes me confused.Thanks,

I have configured the Crypto IPSEC VPN Tunnel in Cisco 2600 but the phase 1 is not established I am sure configuration is correct .. please any one help.Note : Internet is woeking fine.

Hi all.I need to create a rule in my Cisco 1801 router, so that ports such as SMTP, HTTPS, VPN etc, are forwarded to the IP of the Server connected to the Router.How do I create such a rule?I have all the software installed and can access the Firewal...

Dear sir , my requirement is i want connect 38 client office through my 3845 router serial via,is it possiable?

Hi MasterI have vpn tunnel from our HQ to remote site. Can different mtu value caue Network latency. At our HQ it use IP mtu 1350 and remote site use ip mtu 1400. Please advise.ThanksSSai

Hi all,My question is regarding data transfer between two server.Our customer generally complains they have 2mbps bandwidth between hub and remote site however when they are transferring data getting only data transfre rate 360kbps or less then 2mbps...

Why does the corresponding serial interface of an E1 link show the default BW as 1984Kbit instead of the line data rate (=2048Kbit) or its actual data rate (64X30 = 1920Kbit) without framing and signaling ?The confusion is that according to my unders...

Is it possible to bond 4 T1's in a 2811? I heard that I need to go up to a 2821, as the 2811 does not have the horsepower to bundle 4T1's... first I have ever heard of this, and wanted to toss it out there to see if it is a valid statement.*** I want...