Routing

Guys we have a WAN connection to a site.....the router installed at Customer is cisco 2850 which has a VPN (at other end)with check point firewall.....so the router at cutomer end is having a vpn connection with check point and at same time having a ...

As we know when multiple routers are connected to ethernet multiaccess segment only one will be the pim forwarder(DR) and other could be IGMP querier.See the diagram attached.Now if R1 forwards the traffic to multicast host on the segment,Is the Mult...

Hi All,I have a network running OSPF I have 2 internet exit points with the same AS in different locations, OSPF is redistributed at this routers into BGP.So one of the Routers is the exit for the internet.In in the OSFP cloud we have about dozen Rou...

I am trying to apply a policy in my PE router, wich is the interface with the mpls provider network. There is about 250 branches with 1 Mbps BW each one.The most of the traffic is between the central poing and the branches. I applied a policy in the ...

Is there a way to block telnet/ssh/icmp/pop3 on all host for a specific VLAN.Example : We have 10 VLANS configured on the backbone switch and on one VLAN we would like to block traffic in/out telnet/ssh/icmp/pop3

Hello,I'm fairly new to the Cisco IOS, and currently have a problem with a setup for an 877. This 877 the default gateway for a network, and has also a lan to lan vpn that works to my home. The problem is that I can resolve and ping hosts on the inte...

Dear all,My company has a cisco 3620 as a pppoe server for dsl and other services connections that require radius authentication. The set up in this router is working fine with a IOS version 12.2(basically in the setup, we used vpdn groups).Recently,...

Pls refer to the attached diag. We have attempted to do this 3 times now to no avail and I'm hoping someone has seen similar. We put the ASA's into prod and remove the Pixes. All our our external websites and vpn tunnels are accessible after cleari...

I have a simple OSPF setup with Areas 1 & 0. One of the internal routers in Area 1 advertise a default route using "default-information originate....." command.My question is how do I prevent this default route (which appears as type E2 within Area 1...

HiI would like to know how to enable timeout session for Cisco 6506 telnet session.. [ Issue is helpdesk login to 6506 and forget it close and the telnet session remains open... due to this after few sessions we are not alowed to telnet ]...

Dear,I have a Cisco 3845 and one of its Serial Ports is connected to the DR Site.I want to make sure that the link is really 2MBps or not. Is there a show command that would show this type of info? Thanksswami

I have a remote site customer with a second SUP720 that always goes to ROMMON. We just noticed the config-reg is set for 0xC442. We found that it means "invalid NVRAM platform". Any ideas on why this is occuring?