Routing

Sir,Now we are migrating to New Router with 3845 series.Earlier router is 3600 old router.On this router Igrp routing protocol using.But in new router doesn't support igrp routing.Pls confirm whether supports or not

Hi there,I've been working with my Cisco 800 Series router to try to allow access to an internal camera viewing server, and also a few IP cameras.I have added the ip nat inside source static lines into the config, and also the permits to the access l...

Hey,What is Cisco recommend policy on the VPDN source-ip command..Use the global config command:1. vpdn source-ipOrUse the VPDN group command2. source-ipWhich one is recommeneded..PR

What are the E1 network modules/interfaces supported by c1841?Is there a link to for quick reference in general?Show version on a c1841 indicates that it has 1 Channelized E1/PRI port.What could be the corresponding module?Is it NM-1CE1U, NM-1CE1B or...

Hi, I just like to know what is The difference on the router commands "Show Service-Module and Show Controllers T1" and when should we use those 2 commands. Why does Some routers have Show Service-Module command but no Show Controllers T1 or either t...

hi,does it make any difference if my class(es) are in different order.. say default class at the top in a policy and priority class at the bottom.. Will it require extra processing ..Hope I am clear..Thx,GP

Hello!I got a 7500 with BGP running. I want to route packets through a Tunnel that is installed on this machine INSTEAD of sending them to the BGP destination.i tried host routes... this workse.g.ip route 1.2.3.4 255.255.255.255 Tunnel1This is not se...

I use a Cisco 2611XM with NM1E card. I have dual ISP failover scenario using IP SLA.The problem is that my internet runs slow. All the people go to one site to enter data. Here's an output from the router. FastEthernet0/1 is up, line protocol is up ...

HI I am having ADSL line which is provided my BT ( ISP ). I have connected the that Line to ADSL card from router and then I have configured the below. But the link us not coming up please any one help me out please . onfig tinterface ATM0 descripti...

hi,i have ASA 5550 and router 3845. ASA outside interface is connected to router and router is connected to internet. NAT is configured on router. My question is that all my inside clients are connected to ASA inside interface. i want identity nat so...

Hi All,I would like to disable the WEIGHT attribute in BGP calculation algorithm as we have other vendor routers in our network. Is there any way to do itThanks in advance.regards,Arun

Anyone got an idea on how to troubleshoot %AMDP2_FE-5-LATECOLL: Ethernet1/0 transmit error. This interface connects ot a speedstream modem which, in turns connect to a DSL connection.ROUTER(config)#do sh run int ethernet 1/0Building configuration...C...

Hi,I work as an IT consultant, and one of my clients is a small school. They have about 30 computers (15 desktop, 15 laptops), and up until now they've used a consumer-level router (maybe $60). Occasionally it hangs (presumably because of capacity pr...

I asked this in the Certifications forum but it quieted the room:Sethtek-G and Sethtek-H are set up as BGP neighbors in AS 190. PPP serial link between the two, with G's serial IP 172.16.0.1; H's ends in .2.Each has three loopback interfaces configur...