Routing

I have a remote site with a VWIC2-2MFT-T1/E1 Module in a Cisco 2811 router. They are trying to configure a PRI group underneath the controller interface. However the command is not being accepted. Customer has added the ISDN switch type statement (is...

Hi,I hvae an AS that comprises of 16 x /24s.This peering is being done on a 3640.Currently i'm only advertising/peering 8 of theses 16 like so:interface FastEthernet0/0.3 encapsulation dot1Q 230 ip address 216.24.231.1 255.255.255.0 secondary ip addr...

Hello all,I'm currently working at a site with a T1 connection between their main HQ, and remote sites. We are upgrading the existing T1, to a DS3 line, and I've run into a few questions. I've never turned up a DS3 before, so I'm wondering what typ...

I have a 877W router connected to a ISP that offers ADSL2+ connectivity with 20Mb downstream and 1024 upstream. The "sh dsl" command show a 19200 DS and 970 US sync data. The only basic things that I get configured on the router are:- 2 or 3 static P...

What QOS can I use if I want to set (e.g. voice has highest priority to process, web is lowest priority to process)

Hi Folks, hope I'm posting in the right group.Has anyone port-channeled two 10G links across separate line cards in a 7609? I want to create a 20G port-channel between two 7609's but each 10G port on a separate line card (6704). Anyone experience any...

Hi,We have Multiple VLANS and on atleast 5VLANS we have Server's. We would like to the utilization on those VLAN and utilization of those servers ( Conversation between those servers with users or other servers )We have 6506 Catalyst switch with CAT ...

I have the syslog commands on each of the switches but when I run the syslog reports I get nothing. Is there specific commands that I need to add to each of the switches? Logging x.x.x.xLogging trap errorsLogging on

I need to know how much bandwidth can a 1841 router support?

Ive been looking at this and wondering if there is anyway to trace/ping to a server IP address and particular port of thatserver from a router??thx

Hi,I'm currently doing a project to successfully end my apprenticeship.I have some problems now.In general, I want to simulate an DSL-connection between two routers.Therefore I would need two DSL-Lines which I don't have available. So I must at least...

pls i need to know what is passing thru my router, using 'sh nbar ...' giv few information , and majority of the traffic are classified as default, is there any way i can make the router do more traffic identificatiion and less default .

How I can aggregate tow serial interfaces S1/0 & 1/1I need the commands

Is there a US 220V power cable certified to work with the 3845 non-IP power supplies? Or, must I connect the 3845 with 110V in the US? Thanks.

Guys we have a WAN connection to a site.....the router installed at Customer is cisco 2850 which has a VPN (at other end)with check point firewall.....so the router at cutomer end is having a vpn connection with check point and at same time having a ...