Routing

GreetingsI need to create a dial Back up connection that comes from a Cisco 1811 running c181x-adventerprisek9-m 12.4 (6)T7.The router has 1 interface connected that communicates with the Home Branch through a service provider. The router has a VPN c...

Hi,I have an 1812 cisco router, and I have been trying to set this thing up for about a month now.I am using SDM to setup the router but I am unable to set it up successfully.My enviornment:-I have a SBC DSL Connection -Cisco 1812 routerSo far via SD...

is it possible to change destination ip address? example all users use proxy 1.1.1.1 port 3128, i want to redirect destination address with same port to another proxy 2.2.2.2 and keep the same port or even change destination port to 5000.

Hi,Does anybody have documentation on the forwarding rate of the Cisco 12404.

Hi there I have been trying to get a security feature to work on the Cisco 875w router. Basically the router has built in VPN authentication and 6 of these routers are placed in 6 remote workers homes. We want to block all MAC addresses from being ab...

Hello Experts,A client has a BGP load balancing issue. They are multihomed to different providers, and use route-maps matching as-paths to allow routes from specified ASs in, as follows (details altered to protect identities):ISP1 neighbor 1.1.1.1 re...

Can I achieve the Active/ Acive load balancing through GLBP on border rouuters in case I have two Pix Firewalls placed in Active/Passive (Failover mode)and whichever firewall is active pointing default route towards Virtual IP of configured GLBP grou...

Hey there Guys & Gals,I decided to try the compound frame-relay switch configuration using two 2610's. I need to extend the FR clouds to accomendate nine routers. The reference is here: http://www.internetworkexpert.com/resource...frame-relay.htmFor ...

What would be the best router/modules to select for a HQ router that would support 75+ Remote offices via a VPN Tunneling Protocal? Also what 800 series router would work best for the remote sites with quest DSL connection?

i am redistributing connected subnets into OSPF process with following command.redistribute connected subnets.All the routes / connected subnets are successfully distributing into OSPF, but there is a connected network on the device which i dont want...

Cisco 1841 router connected up to a T1. Router is subnetted on the two interfaces with one of the interfaces going to a Cisco PIX and the other one goes directly to a Polycom teleconferencing device.We want all 1.5mbit available EXCEPT when the Polyc...

I am looking for a solution to use static nat translation on both sides of a router (not an ASA/PIX).Situation:server-1 (212.123.200.1) on fa0/1 server-2 (192.168.10.101) on fa0/0fa0/0 = ip nat insidefa0/1 = ip nat outsideTo translate server-2 on out...

Hi guys,I have some changes on my network and i am trying to figure out a way to get it work. but I must say i am a bit lost.I was given this requirements:1) connect to 2 MPLS providers2) Traffic that doesnt require to be NATed is send out the MPLS r...

Hello y'all.We are trying to setting up our CiscoWorks-Syslog, in order to separate the logs that comming from CISCO-ASA and CISCO-6500. Today ASA and 6500 send the logs to Syslog Server and the log file is too big (more then 15Gb). We'd like to sepa...

How do i get round forgotten password problem on Router 1841