Routing

Hi, My Cisco3845 came with a redundant power supply and I want to remove it. However, power supply failure error msg prompts after I has removed the redundant unit. What can I do to stop the router from detecting the redundant power supply? Thanks.

Hello NetPros,As anyone come across issues where a serial connection (say s0/1) going down, tend to bring down another serial connection.The scenerio is that, say RouterA has 2 serial interfaces s0/1 and s0/2. s0/1 is a ppp connection via a V100 sate...

Hi guysWe are a UK based company.We have Cisco 2610 ISDN Router that has worked fine for the last five years. We have now moved offices, and it is unhappy. We use the router to dial out to customer sites. The config has not changed since the move, c...

I need to run firmware version 3.0.33 on my hwic-1adsl card in my 2811there is a firmware upgrade process for the 1800 but this does not work on the 2800 and ideas ?, running c2800nm-advipservicesk9-mz.124-15.T1.bin

Hi, I still have doubt on this even after reading 100 times. Hold down timer is intiated when the router recives an update with metric higher than the current metric it has. (1) Split horizon with route poison sends back few updates with metric 16...

What is the purpose of this? Do we need these feature utilized if we ever are going to have to troubleshoot DHCP issues?Thanks

Hello--I'm running VOIP over a frame-relay WAN and have configured QoS on all routers to prioritize voice traffic. It seems to be working, but I have some questions about the configuration. Setup is a main corporate site connected to 6 remote sites ...

Hi,There is a router which was connected to switch by router fast ethernet and router fast ethernet ip subnet is 10.160.16.0 /24.This router fast ethernet ip is10.160.16.254/24Now I want to connect another router to the same switch and use the ip fro...

Does anyone know where I can get detail information on configuring an AAA server and Pix firewall so a client can connect using Cisco VPN Client v 4.0.4?

I'm having a problem in which client computers are pulling ip addresses from the wrong DHCP server.We have a hub and spoke topology and each site is connected to the hub via Metro Ethernet. 3750G core switches are responsible for routing at each site...

How can I use different local AS# for each VRF as we are trying to convert a Juniper MPLS network to use Cisco but their current Juniper routers has different local AS# per VRF and don't know if we can do that for IOS?Example:router bgp 2 bgp log-nei...

Where can I find info about harden the ASA? Is it pre-hardened?