Routing

Dear All,We have a cisco ASR 1001 router that is running with IOS XE Version: 03.06.00.S.  This router required to upgrade with 3.16.10S(MD). So would like to know that this IOS XE 3.16.10S(MD) support standard licencing or we need to change licensin...

HiI have a fairly unusual question. I have a C1111X-8P router that I need to run directly from an USBdevice. So I can disable the internal flash.So when I power off the unit and remove the USBdevice no traces of the configuration, IOS, VLAN, logs etc...

Hi, I configured IPSec on Cisco 1941 (c1900-universalk9-mz.SPA.157-3.M8.bin).- I can connect via IPSEC- I can ping from the IPSEC-client to the router and servers with the 192.168.0.x IP address behind Cisco 1941 router- I can not do SSH to any 192.1...

Hello guys ,  I have a very weird issue , actually I will try to be clear as much as i can : we have a backup application located on a site 1 , connected to Site 2 , the DB is connected to a cluster of ISR 4431 working as a firewall for inspecting th...

Hi,What is the explanation of the option " match-in-vrf" in the command ip nat inside source?Because nothing is explain on the CCO.router(config)#ip nat inside source list TEST pool POOL_TEST vrf VRF_TEST ?match-in-vrf Match incoming vrf overload ...

Hello, I'm looking for except script That will able to run command show run int g0/0.x on 4,094 vlan's  ThanksRouting  

1. Why area 0 is required? Per RFC 3509 two non-backbones area cannot communicate and to ensure a loop free topology in a multi area design, especially with redundant paths , we need a central point and a reference to calculate the best path without ...

Hi, I have a new cisco 4221 router .I put in passwords during initial configs and an IPUnfortunately, now it cannot accept passwords and i cant access it using GUI yet i can successfully ping it.I have tried several recovery methods using SSH, Serial...

Hi Sir, I need eight 1G port and enght 10G port in the ASR 1001HX (or in the 1002HX). How many port license should I buy? Thanks. Justin

I have 'had' a situation where I have a class configured with bandwidth remaining percent and a policer.class INTERACT  bandwidth remaining percent 9  random-detect dscp-based  random-detect dscp 26 32 40 10  queue-limit 128 packets  police cir perce...

Hi all, I need to configure this command "service-policy output X" to different IPSEC tunnels. I can apply it to all tunnels, no errors. But if I do a "show policy-map interface", I see only one tunnel Router: cisco ASR1002-X (2RU-X)Config:rtcore(con...