Hi Everyone,
I'm having a bit of a struggle with configuring my brand new 1921 router. I think something goes wrong with setting the default gateway:
Config is like this:
---
Current configuration : 3906 bytes
!
version 15.1
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname rt
!
boot-start-marker
boot-end-marker
!
logging buffered 51200
enable secret 5 xxx
!
no aaa new-model
clock timezone PCTime 1
clock summer-time PCTime date Mar 30 2003 2:00 Oct 26 2003 3:00
!
no ipv6 cef
ip source-route
no ip routing
no ip cef
!
ip domain name not-public
ip name-server 8.8.8.8
ip name-server 8.8.4.4
multilink bundle-name authenticated
!
license udi pid CISCO1921/K9
!
interface GigabitEthernet0/0
description $ETH-LAN$
ip address 192.168.241.254 255.255.255.0
ip nat inside
ip virtual-reassembly
no ip route-cache
duplex auto
speed auto
!
interface GigabitEthernet0/1
description $ETH-WAN$
ip address dhcp client-id GigabitEthernet0/1
no ip route-cache
duplex auto
speed auto
!
interface FastEthernet0/0/0
!
interface FastEthernet0/0/1
!
interface FastEthernet0/0/2
!
interface FastEthernet0/0/3
!
interface Vlan1
description $ES_LAN$
ip address 192.168.240.254 255.255.255.0
no ip route-cache
no mop enabled
!
ip forward-protocol nd
!
ip http server
ip http access-class 23
ip http authentication local
ip http secure-server
ip http timeout-policy idle 60 life 86400 requests 10000
!
ip nat inside source list 2 interface GigabitEthernet0/1 overload
ip route 192.168.226.0 255.255.255.0 Vlan1 192.168.240.253
ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/0 dhcp
!
access-list 2 remark CCP_ACL Category=2
access-list 2 permit 192.168.241.0 0.0.0.255
access-list 23 remark CCP_ACL Category=17
access-list 23 permit 192.168.240.0 0.0.0.255
access-list 23 permit 192.168.226.0 0.0.0.255
!
control-plane
!
line con 0
login local
line aux 0
line vty 0 4
access-class 23 in
privilege level 15
login local
transport input telnet ssh
line vty 5 15
access-class 23 in
privilege level 15
login local
transport input telnet ssh
!
scheduler allocate 20000 1000
end
---
A bit of history:
I outgrew my ZyWall (or had to admit that it was a piece of junk), so I purchased an ASA 5505 to replace it. Only to learn that an ASA only has one active connection at the time. So the next move was to get a router to put in front of the ASA to handle my two lines concurrently. I have a 90 Mbit fiber connection with a "DHCP Static IP" and 20/10Mbit with regular static IPs. The slow line is running on my ASA right now, so I have been trying to configure the fast line on the router and when I have that working, I will migrate the other line.
But I'm stuck at configuring the WAN connection. Can some one please give some advice on what I'm doing wrong?
