clear policy-map counters

[p.diaz]

Hi

Can Everybody tell me how can I clear the counters of the policy-map statistics in an 7600 and the 1841 router?

thanks

[Gregory Camp]

clear counters FastEthernet0/1 (or any other interface)

[p.diaz]

hi Greg.

but that command doesnt clear the drops stadistics? tks

[Gregory Camp]

It should, what IOS are you running? Send me the output of sh policy-map int before and after clearing the counters.

[joshua.wilson]

You could bounced the qos policy config...take it out and put it back in.

[pierre-marc.lize]

Hi,

Ran accross this too,

Routeur wouldn't clear the policy-map counters (sh policy-map int xx) when clearing the specific interface...

Try clearing counters for all interfaces, worked for me..

ie:

clear counters

!## Make sure you hit enter to confirm at this prompt : Clear "show interface" counters on all interfaces [confirm]

Good Luck

[chad.kibler]

Hi,

On my Cisco 2821 I used the following to clear the Service Policy counters on the Multilink interface.

clear counters mu1

or

clear counters multilink 1

Hopes this helps.

Chad

[redray_76]

clear qos counters int XXXXBLA.BLA.BLA (as an example)

[redray_76]

My prior response is on a 9K

[aaron richardson]

This is the correct answer. "clear counters"

[kesva.naidoo]

The only way I could reset the policy-map counters on an interface was remove it from the interface and put it back on.