02-15-2020 07:19 AM
Hi CSC,
For configuration of the above module for data, is there a generic config that would be applied across the board or are there certain parameters that need to be supplied by the actual circuit provider? Not something I have configured previously. Is this the correct configuration guide?
Thanks
Solved! Go to Solution.
02-15-2020 08:10 AM
Hello,
typically, the only settings that might be different depending on the provider you have and/or the region you are in are framing and linecoding. When the line is provisioned, the ISP usually tells you which values you need to configure...
02-15-2020 08:10 AM
Hello,
typically, the only settings that might be different depending on the provider you have and/or the region you are in are framing and linecoding. When the line is provisioned, the ISP usually tells you which values you need to configure...
02-15-2020 08:15 AM
02-15-2020 08:25 AM
Hello,
the guide is very comprehensive and covers all settings, so that's probably all you need. If you run into any problems, post here again...
02-16-2020 03:43 AM
Hi Georg, quick addition to this - does this nim default to a particular speed, e.g if the link provided is a 2mbps, I'm wondering if shaping would be required, or if there is a part of the e1 config that hard codes the speed to say 2Mbps
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide